Hi Janusz ,
Thanks for the reply
I looked into the hostapd_cli ,
chan_switch only gives the following help .
usage: <cs_count> <freq> [sec_channel_offset=] [center_freq1=]
[center_freq2=] [bandwidth=] [blocktx] [ht|vht]
I further found out that cs_count stands ,switch channel after number of
beacon frames
and freq should be channel number
For example if would want change the channel from 1 to 11 , it tried
out the following command
> chan_switch 500 11
FAIL
> chan_switch 50 11
FAIL
> chan_switch 25 11
FAIL
please let me know if i am doing something wrong or please point out if
any correct examples are there (on the net).
Regards
Nagaraj
i
On Tuesday 02 February 2016 01:59 PM, Janusz Dziedzic wrote:
On 2 February 2016 at 07:34, Nagaraj Nayak <nagarajn@xxxxxxx> wrote:
Hi
I have bee testing with hostapd2.4 and hostapd2.5
In both version which I give SIGHUP command only the ssid and password
changes are getting effected ,
But the channel configured doesn't seem to change ,
Is there any method by which the channel can be changed without bringing
down the hostapd .
>From hostapd_cli you can run chan_switch.
BR
Janusz
Regards
Nagaraj
_______________________________________________
Hostap mailing list
Hostap@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/hostap
_______________________________________________
Hostap mailing list
Hostap@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/hostap
