Hi all, Sending this mail again, since I did not get any responses till now for below questions. I would like to test MacSec (802.1ae/802.1x-2010) support in wpa_supplicant as EAP-TLS-peer and hostapd as EAP-TLS-authenticator and I have some questions regarding this. 1. Are WPA supplicant & hostapd 802.1x-2010 standard compliant? 2. I see MACSec is implemented on qca drivers. I can't find any information about these drivers. Could you give details on which testing framework was used to test MACSec? Is MACSec using Pre-shared Key is supported.? 3. Can we enable MACSec on wired interface of hostapd acting as EAP-TLS-authenticator or EAP-TLS-server? Thanks in advance and regards, Badrish On Thu, Jan 21, 2016 at 12:18 PM, Badrish Adiga H R <badrish.adigahr@xxxxxxxxx> wrote: > Hi all, > > I would like to test MacSec (802.1ae/802.1x-2010) support in > wpa_supplicant as EAP-TLS-peer and hostapd as EAP-TLS-authenticator > and I have couple of questions regarding this. > > 1. Are WPA supplicant & hostapd 802.1x-2010 standard compliant? > 2. I see MACSec is implemented on qca drivers. I can't find any > information about these drivers. Could you give details on which > testing framework was used to test MACSec? Is MACSec using Pre-shared > Key is supported.? > 3. Can we enable MACSec on wired interface of hostapd acting as > EAP-TLS-authenticator or EAP-TLS-server? > > Thanks regards, > Badrish _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap