From: Avraham Stern <avraham.stern@xxxxxxxxx> In cases that the bandwidth is not set when starting an AP/P2P GO, the code tries to use 160MHz or 80MHz channels. As a result, the AP/P2P GO configuration is set to use these channel widths even if they are not available, which may results in failing to start the AP/P2P GO. Fix this by changing the AP/P2P GO configuration not to use VHT channels when they are not available. In this case the AP/P2P GO will use a 40MHz channel if available, or a 20MHz channel if this is the maximum available width. Signed-off-by: Avraham Stern <avraham.stern@xxxxxxxxx> --- wpa_supplicant/ap.c | 1 + 1 file changed, 1 insertion(+) diff --git a/wpa_supplicant/ap.c b/wpa_supplicant/ap.c index 105fb1c..98b9596 100644 --- a/wpa_supplicant/ap.c +++ b/wpa_supplicant/ap.c @@ -92,6 +92,7 @@ no_vht: conf->vht_oper_centr_freq_seg0_idx = conf->channel + conf->secondary_channel * 2; #endif /* CONFIG_P2P */ + conf->vht_oper_chwidth = VHT_CHANWIDTH_USE_HT; } #endif /* CONFIG_IEEE80211N */ -- 1.9.1 _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap
