We configured an AP to run on channel 6, HT40+. But, due to scan results, it decided it could only run HT20 due to overlapping BSS. The scan results show it as having HT20/40 capability but no secondary channel. Is this expected? I was thinking it might should not be advertising the HT40. We are running local patches, possibly we messed up something. Thanks, Ben BSS 04:f0:21:7d:cc:36(on sta13) -- associated TSF: 0 usec (0d, 00:00:00) freq: 2437 beacon interval: 240 TUs capability: ESS ShortSlotTime (0x0401) signal: -18.00 dBm last seen: 1 ms ago Information elements from Probe Response frame: SSID: brenttest-10k Supported rates: 1.0* 2.0* 5.5* 11.0* 6.0 9.0 12.0 18.0 DS Parameter set: channel 6 ERP: Barker_Preamble_Mode Extended supported rates: 24.0 36.0 48.0 54.0 HT capabilities: Capabilities: 0x6e HT20/HT40 SM Power Save disabled RX HT20 SGI RX HT40 SGI No RX STBC Max AMSDU length: 3839 bytes No DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 8 usec (0x06) HT TX/RX MCS rate indexes supported: 0-23 HT operation: * primary channel: 6 * secondary channel offset: no secondary * STA channel width: 20 MHz * RIFS: 0 * HT protection: no * non-GF present: 1 * OBSS non-GF present: 0 * dual beacon: 0 * dual CTS protection: 0 * STBC beacon: 0 * L-SIG TXOP Prot: 0 * PCO active: 0 * PCO phase: 0 Extended capabilities: SSID List, 6 WMM: * Parameter version 1 * BE: CW 15-1023, AIFSN 3 * BK: CW 15-1023, AIFSN 7 * VI: CW 7-15, AIFSN 2, TXOP 3008 usec * VO: CW 3-7, AIFSN 2, TXOP 1504 usec -- Ben Greear <greearb@xxxxxxxxxxxxxxx> Candela Technologies Inc http://www.candelatech.com _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap