On Fri, Oct 23, 2015 at 04:42:20PM -0700, Frank Rizzo wrote: > When I launch hostap, it creates the vlans listed in the config file: > > 2 vlan2 > 3 vlan3 > 4 vlan4 > > And the bridges to support them. But all without IP addresses. > > I used some other tools (vconfig, ipconfig, etc.) to create the > components BEFORE launching hostap, and it errors out. > > So, my question, what is the CORRECT way to setup the vlans, and > bridges so that hostap can open them, AND they have the correct IP > addresses? If this is for an interface that hostapd adds dynamically, the only currently available option would be to have some external component follow interface addition (or setting UP) events (e.g., from netlink RTM_NEWLINK) and perform the needed configurations steps once the netdev is up. -- Jouni Malinen PGP id EFC895FA _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap