In beagleplay beagleconnect setup, the AP is not directly connected to greybus nodes. The SVC and APBridge tasks are moved to cc1352 coprocessor. This means that there is a need to send cport information between linux host and cc1352. In the initial version of the driver (and the reference implementation gbridge I was using), the greybus header pad bytes were being used. However, this was a violation of greybus spec. The following patchset creates a wrapper around greybus message to send the cport information without using the pad bytes. Ayush Singh (1): greybus: gb-beagleplay: Remove use of pad bytes drivers/greybus/gb-beagleplay.c | 44 +++++++++++++++++++++++---------- 1 file changed, 31 insertions(+), 13 deletions(-) -- 2.43.0 _______________________________________________ greybus-dev mailing list -- greybus-dev@xxxxxxxxxxxxxxxx To unsubscribe send an email to greybus-dev-leave@xxxxxxxxxxxxxxxx