Help - config or network issue

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]


Hi all,

I am getting a lil lost and not sure where to find the issue.
Let me first describe the situation.

I have a small ipv4 subnet which is not having any firewalling so openly connected to the internet.

If I give a tandberg 880 unit a public IP of this subnet I am able to call and to be called. But of course I also receive lots of unwanted calls.

I want to use gnugk as a gatekeeper, but also to make sure not every default call just comes in.

When I use gnugk and I have tried various configs I never am able to receive a successfull call on the tandberg unit. There is a connection but only the incoming video is shows on the tandberg screen, the tanberg video does not come to the other endpoint.

I have gnugk installed on a raspberry with the following IP config:
eth0      inet addr:  Bcast:  Mask:
eth0.0   inet addr:  Bcast:  Mask:

with the following routing table:
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
default         a80-127-117-170         UG    202    0        0 eth0  *      U     202    0        0 eth0     *        U     0      0        0 eth0

The endpoint is having a static address on the network.
for this network there is no specific router, I assume the raspberry with gnugk will deal the the needfull things.

Can some of you advise me or share a config example?
I dont think the is a too unique situation.



Check out the vibrant tech community on one of the world's most
engaging tech sites,!

Posting: mailto:Openh323gk-users@xxxxxxxxxxxxxxxxxxxxx

[Index of Archives]     [SIP]     [Open H.323]     [Gnu Gatekeeper]     [Asterisk PBX]     [ISDN Cause Codes]     [Yosemite News]

  Powered by Linux