Again, audio and video is no indication that the call has connected (and would be past most of the message timeouts). You have to check for the Connect message and check if the H.245 connection negotiated properly. Regards, Jan Mikael Grehn wrote: > Hi Jan and thanks for the rapid response. > > The calls are perfectly connected and they run with audio and video for about 25 seconds (perhaps 20 seconds after fully being connected). Then the primary gatekeeper is sending this disengageRequest to Mirial and Mirial disconnects both sides. Primary gatekeeper has been "quiet" for about 20 seconds before this so something is absolutely happening! > > If I make a call to the other customer (directly to primary Gk) the call is not disconnected at all and are working perfectly. :) > > Any ideas what can trigger this? > > Thanks for you kind help! > > Best Regards, > Mikael > > > -----Ursprungligt meddelande----- > Från: Jan Willamowius [mailto:jan@xxxxxxxxxxxxxx] > Skickat: den 29 november 2011 20:21 > Till: openh323gk-users@xxxxxxxxxxxxxxxxxxxxx > Ämne: Re: Question about disengageRequest > > Hi Mikael, > > are your calls being terminated before or after they connect ? (Hearing voice may just mean that the call was using FastStart.) > > If GnuGk actively terminates a call it usually detected ran into a timeout (it tries to detect stale calls). When you have multiple gatekeepers involved, make sure each gatekeeper that handles the call sees all messages for that call. > > Regards, > Jan > > > Mikael Grehn wrote: > > Hi! > > > > I have a question about why a primary gatekeeper(out of 2 gatekeepers) > > is disconnecting calls after 25 seconds that first reaches the > > alternative gatekeeper on another machine. The H323 endpoint that is > > receiving the call is a Mirial gateway. :) > > > > We have two customers that use incoming H323 and SIP for their service. > > > > For the H323 we are using a H323 Gnugk for each customer (on two different IP's) that I have tried to setup as primary and alternative gatekeeper. > > To translate from H323 to SIP (which is the protocol mainly supported > > by our service) we have a Mirial H323 2 SIP in between. The H323 side > > of Mirial is registered in the primary gatekeeper at customer 1. We > > cant register it in the alternative as well. :) > > > > > > Customer 1: GnuGk(primary) IP1 <--registered Mirial IP3 > > |reg > > Customer 2: GnuGk(alternative) IP2 > > > > > > Calls from H323 clients to the first (primary) customer is working perfectly. > > Calls from H323 to the second customer (with the alternative gatekeeper gets the call to work for about 25 seconds. After this the primary gatekeepers decides to send disengageRequest directly to Mirial gateway, that is later disconnecting the calls. > > > > This is the log from the primary gatekeeper (207.183.111.122) when it is disconnecting a working call: > > > > (. . . about 20 seconds with no logs since the call was setup OK . . > > .) disengageRequest { > > requestSeqNum = 104 > > endpointIdentifier = 9 characters { > > 0031 0034 0030 0038 005f 0065 006e 0064 1408_end > > 0070 p > > } > > conferenceID = 16 octets { > > 02 35 81 01 a4 43 d0 10 36 b3 e2 73 30 a9 2e cf .5...C..6..s0... > > } > > callReferenceValue = 51145 > > disengageReason = forcedDrop <<null>> > > callIdentifier = { > > guid = 16 octets { > > 02 35 81 01 a4 43 d0 10 36 b2 e2 73 30 a9 2e cf .5...C..6..s0... > > } > > } > > gatekeeperIdentifier = 6 characters { > > 0047 0047 006e 0075 0047 006b GGnuGk > > } > > answeredCall = false > > } > > 2011/11/29 12:55:55.689 2 RasTbl.cxx(2642) Gk Disconnect Call No. 26 > > 2011/11/29 12:55:55.689 2 RasTbl.cxx(4076) CDR ignore not connected call > > 2011/11/29 12:55:55.689 2 gkacct.cxx(955) GKACCT Successfully logged event 2 for call no. 26 > > 2011/11/29 12:55:55.690 2 RasSrv.cxx(173) RAS Read from 207.183.111.224:1719 > > 2011/11/29 12:55:55.690 3 RasSrv.cxx(223) RAS > > disengageConfirm { > > requestSeqNum = 104 > > usageInformation = { > > nonStandardUsageFields = 0 entries { > > } > > alertingTime = 1322592922 > > connectTime = 1322592926 > > } > > } > > 2011/11/29 12:55:55.690 1 RasSrv.cxx(355) RAS DCF Received from 207.183.111.224:1719 > > 2011/11/29 12:55:56.689 3 RasTbl.cxx(2130) Gk Delete Call No. 26 > > 2011/11/29 12:55:57.278 2 RasSrv.cxx(173) RAS Read from 207.183.111.224:1719 > > 2011/11/29 12:55:57.278 3 RasSrv.cxx(223) RAS > > disengageRequest { > > requestSeqNum = 60528 > > endpointIdentifier = 9 characters { > > 0031 0034 0030 0038 005f 0065 006e 0064 1408_end > > 0070 p > > } > > conferenceID = 16 octets { > > 02 35 81 01 a4 43 d0 10 36 b3 e2 73 30 a9 2e cf .5...C..6..s0... > > } > > callReferenceValue = 18377 > > disengageReason = normalDrop <<null>> > > callIdentifier = { > > guid = 16 octets { > > 02 35 81 01 a4 43 d0 10 36 b2 e2 73 30 a9 2e cf .5...C..6..s0... > > } > > } > > gatekeeperIdentifier = 6 characters { > > 0047 0047 006e 0075 0047 006b GGnuGk > > } > > answeredCall = true > > usageInformation = { > > nonStandardUsageFields = 0 entries { > > } > > alertingTime = 1322592922 > > connectTime = 1322592926 > > endTime = 1322592952 > > } > > terminationCause = releaseCompleteReason gatekeeperResources <<null>> > > } > > 2011/11/29 12:55:57.279 1 RasSrv.cxx(355) RAS DRQ Received from 207.183.111.224:1719 > > 2011/11/29 12:55:57.279 2 RasSrv.cxx(395) DCF|207.183.111.224|1408_endp|18377|normalDrop|02-35-81-01-a4-43-d0-10-36-b2-e2-73-30-a9-2e-cf; > > 2011/11/29 12:55:57.279 3 RasSrv.cxx(235) RAS Send to 207.183.111.224:1719 > > disengageConfirm { > > requestSeqNum = 60528 > > } > > > > Any ideas why it does this and how I can configure it away? > > I am adding the gnugk.ini file from primary gatekeeper. It is very > > similar on the alternative one. :) > > > > Primary Gk: 207.183.111.222 > > Alternativ Gk: 207.183.111.223 > > Mirial h323 2 SIP gw: 207.183.111.224 > > > > [Gatekeeper::Main] > > FortyTwo=42 > > Name=GGnuGk > > TimeToLive=600 > > StatusTraceLevel=2 > > AlternateGKs=207.183.111.223:1719:false:120:CGnuGk > > SendTo=207.183.111.223:1719 > > SkipForwards=207.183.111.223 > > CompareAliasCase=0 > > CompareAliasType=0 > > ExternalIP=207.183.111.222 > > [GkStatus::Auth] > > rule=allow > > 127.0.0.1=allow > > default=allow > > Shutdown=allow > > > > [RoutedMode] > > GKRouted=1 > > H245Routed=0 > > CallSignalPort=1720 > > AcceptUnregisteredCalls=1 > > DropCallsByReleaseComplete=1 > > SupportNATedEndpoints=1 > > > > [Proxy] > > Enable=0 > > ProxyForNAT=1 > > ProxyForSameNAT=0 > > > > [RoutingPolicy] > > default=explicit,internal,parent,neighbor,catchall,vqueue > > > > [RasSrv::RewriteAlias] > > customerdomain.com=0099999999 > > > > [Routing::CatchAll] > > CatchAllAlias=PSEGateway > > > > [EP::PSEGateway] > > Capacity=30 > > AddNumbers=0099999999 > > AdditionalDestinationAlias=0099999999 > > > > I have tried to change the real IP's into fictional ones, might have missed some! > > Any help is very appreciated! :) > > > > Best Regards, > > Mikael -- Jan Willamowius, jan@xxxxxxxxxxxxxx, http://www.gnugk.org/ ------------------------------------------------------------------------------ All the data continuously generated in your IT infrastructure contains a definitive record of customers, application performance, security threats, fraudulent activity, and more. Splunk takes this data and makes sense of it. IT sense. And common sense. http://p.sf.net/sfu/splunk-novd2d _______________________________________________________ Posting: mailto:Openh323gk-users@xxxxxxxxxxxxxxxxxxxxx Archive: http://sourceforge.net/mailarchive/forum.php?forum_name=openh323gk-users Unsubscribe: http://lists.sourceforge.net/lists/listinfo/openh323gk-users Homepage: http://www.gnugk.org/
