how many bytes of SMTP traffic could be saved if someone just reads the tutorial. AcceptUnregisteredCalls=1 Default: 0 With this feature enabled, the gatekeeper will accept calls from any unregistered endpoint. However, it raises security risks. Be careful to use it. On Thursday 13 January 2005 11:47, raymond wrote: > Hi Stewart, > > I change the config as you mentioned but now the call is release with "call > rejected" > > ====cisco cdr=== > 341E : 1017845538hs.31511 +-1 +4 pid:10997022 Originate 99702285222111888 > dur 00:00:00 tx:0/0 rx:0/0 15 (call rejected (21)) > IP 0.0.0.0:0 rtt:0ms pl:0/0ms lost:0/0/0 delay:0/0/0ms g729r8 pre-ietf > > ====debugger log of gnugk=== > 2005/01/13 09:19:37.857 3 ProxyChannel.cxx(687) Q931s Received: > Setup CRV=4927 from 202.147.20.195:16866 2005/01/13 09:19:37.861 3 > gkauth.cxx(1224) GKAUTH default Setup check ok 2005/01/13 09:19:37.861 > 3 ProxyChannel.cxx(1348) Q931 Reject unregistered call 9f 53 d5 > 86 64 78 11 d9 a2 47 a0 1b e8 16 79 3a 2005/01/13 09:19:37.862 2 > RasTbl.cxx(1855) CallTable::Insert(CALL) Call No. 6, total sessions : 1 > 2005/01/13 09:19:37.862 3 gkacct.cxx(896) GKACCT SQLAcct > logged event 1 for call no. 6 2005/01/13 09:19:37.863 2 > gkacct.cxx(936) GKACCT Successfully logged event 1 for call no. 6 > 2005/01/13 09:19:37.863 1 RasTbl.cxx(2022) CDR|6|9f 53 d5 86 > 64 78 11 d9 a2 47 a0 1b e8 16 79 3a|0|unconnected|Thu, 13 Jan 2005 09:19:37 > GMT|202.147.20.195:16866| |0.0.0.0:0| > |99702285222111888:dialedDigits|nygtas01:h323_ID|NYGTGK02; > > 2005/01/13 09:19:37.866 3 gkacct.cxx(896) GKACCT SQLAcct > logged event 2 for call no. 6 2005/01/13 09:19:37.866 2 > gkacct.cxx(936) GKACCT Successfully logged event 2 for call no. 6 > 2005/01/13 09:19:37.868 3 yasocket.cxx(528) Q931s Delete > socket 202.147.20.195:16866 2005/01/13 09:19:37.947 3 > RasTbl.cxx(1333) Gk Delete Call No. 6 > > > > > From: Stewart Nelson <sn@xxxxx> > Re: Cannot make call from GW (that is not registered to GNUGK but defined > as permanent EndPoint) 2005-01-12 00:49 > > Hi Ray, > > I assume that you meant to say: > 3. GW (not registered) -----> GNUGK ----> GW (registered) FAIL > If not, please explain. > > Make sure that you set > [RoutedMode] > CallSignalPort=1720 > or, you configure the calling endpoint to contact gnugk on port 1721. > > If that doesn"t help, please supply some trace output on failed call. > If there isn"t any, make sure that endpoint is sending Setup to gnugk > IP and proper port. > > --Stewart > > ----- Original Message ----- > From: "raymond" <ray_nygt2004@xxxxx> > To: <openh323gk-users@xxxxx> > Sent: Wednesday, January 12, 2005 9:12 AM > Subject: Cannot make call from GW (that is not > registered to GNUGK but defined as > permanent EndPoint) > > > Hi all, > > I define a GW as permanent EndPoint by [RasSrv::PermanentEndPoints]. I > found it is just the same as > registered GW from the status port. > ==gnugk config=== > [RoutedMode] > GKRouted=1 > H245Routed=1 > > [Proxy] > Enable=1 > ProxyForNAT=1 > > [RasSrv::PermanentEndpoints] > ; For gateway > XXX.XXX.XXX.XXX=ABCD;1234 > ==gnugk config=== > > Then I make some call testing and the following is my findings: > Call Types: > 1. GK (registered) -----> GNUGK ----> GK (registered) > PASS 2. GK (registered) -----> GNUGK ----> GK (not registered) > PASS 3. GK (not registered) -----> GNUGK ----> GK (registered) > FAIL > > Can anyone advise me what goes wrong? > > Thanks. > > Ray Lau ------------------------------------------------------- The SF.Net email is sponsored by: Beat the post-holiday blues Get a FREE limited edition SourceForge.net t-shirt from ThinkGeek. It's fun and FREE -- well, almost....http://www.thinkgeek.com/sfshirt _______________________________________________________ List: Openh323gk-users@xxxxxxxxxxxxxxxxxxxxx Archive: http://sourceforge.net/mailarchive/forum.php?forum_id=8549 Homepage: http://www.gnugk.org/
