Hi Andrew, An endpoint in this case is either a terminal, gateway, gatekeeper or mcu. So basically it depends how you want to do this. If you want to setup all your endpoints to use RAS, then all your endpoints must register to the gatekeeper. In this case your Cisco 5300 must register to your gatekeeper, problem with this is that if this is not your gateway, some providers will not want to register it to your gatekeeper, because chances are they have already register it with their own gatekeeper which controls their own zone. Therefore, you must set the Cisco 5300 as a PermanentEndpoint endpoint in the configuration file. Example: [RasSrv::PermanentEndpoints] 123.123.123.123=gw5300;8888 [RasSrv::RewriteE164] 21232=8888 However, if your carrier does allow you to register to your gatekeeper, then it will register with an alias to the gatekeeper. Your ATAs will then be able to send calls to your cisco 5300. What i'm not sure about in this case is whether one of your register endpoints(ATAs) can route the call to your cisco 5300 by alias only with out using an E.164 number. I know that if its a terminal, you can do it by alias, but i haven't tested whether you can route to a gateway by using an alias. Anyone know if this is possible? Example: [RasSrv::GWPrefixes] gw5300=8888 [RasSrv::RewriteE164] xxxxx=xxxx In this case assumming your cisco 5300 registered to the gatekeeper with an alias of gw5300, all calls will be routed to this gateway starting with prefix 8888 for an E.164 number. Freddy -----Original Message----- From: Andrew Croch [mailto:o_engenheiro71@hotmail.com] Sent: Wednesday, December 03, 2003 9:57 AM To: openh323gk-users@lists.sourceforge.net Subject: RE: Gateway Gatekeeper Registration Process Freddy, thank you for your response. When I say gateway I mean a Cisco 5300 for instance and not an endpoint. I read the whole manual and I think it is not complete with regard to the gateway registration/alias atribution with the gatekeeper. I have 4 ATA boxes conected to the gatekeeper. I have a Cisco 5300 located in a carrier. How can direct the calls from the ATAs to the 5300 ? As far as I understood, I need to make the 5300 register itself to the GK, right ? And then use the alias provided by the 5300 to the GK, right ? I want to understand how this registration process works. Thanks again Andrew >From: "Freddy Parra" <fparra@numind.net> >Reply-To: openh323gk-users@lists.sourceforge.net >To: <openh323gk-users@lists.sourceforge.net> >Subject: RE: Gateway Gatekeeper Registration Process >Date: Tue, 2 Dec 2003 17:59:42 -0500 > >The gateway doesn't have to register with the gatekeeper. You can have >unregister endpoints >send calls to the gatekeeper. Just make sure you set the gatekeeper to >accept unregister endpoints. >All the questions that you have asked are in the manual. > >Freddy > >-----Original Message----- >From: Andrew Croch [mailto:o_engenheiro71@hotmail.com] >Sent: Tuesday, December 02, 2003 5:18 PM >To: openh323gk-users@lists.sourceforge.net >Subject: Gateway Gatekeeper Registration Process > > >Hi All, > >Where can I find information on the registration process between a >gatekeeper and a gateway ? >AS far as I understood from the gnugk manual, it can only uses a gateway if >it was previously registred. Is this right ? > >WHO DETERMINES THE ALIASES OF THE GATEWAYS IN THE GNUGK ? > >Thanks a lot, >Albert > >_________________________________________________________________ >online games and music with a high-speed Internet connection! Prices start >at less than $1 a day average. https://broadband.msn.com (Prices may vary >by service area.) > > > >------------------------------------------------------- >This SF.net email is sponsored by: SF.net Giveback Program. >Does SourceForge.net help you be more productive? Does it >help you create better code? SHARE THE LOVE, and help us help >YOU! Click Here: http://sourceforge.net/donate/ >_______________________________________________ >List: Openh323gk-users@lists.sourceforge.net >Archive: http://sourceforge.net/mailarchive/forum.php?forum_id=8549 >Homepage: http://www.gnugk.org/ > > >------------------------------------------------------- >This SF.net email is sponsored by: SF.net Giveback Program. >Does SourceForge.net help you be more productive? Does it >help you create better code? SHARE THE LOVE, and help us help >YOU! Click Here: http://sourceforge.net/donate/ >_______________________________________________ >List: Openh323gk-users@lists.sourceforge.net >Archive: http://sourceforge.net/mailarchive/forum.php?forum_id...49 >Homepage: http://www.gnugk.org/ _________________________________________________________________ Shop online for kids' toys by age group, price range, and toy category at MSN Shopping. No waiting for a clerk to help you! http://shopping.msn.com ------------------------------------------------------- This SF.net email is sponsored by: SF.net Giveback Program. Does SourceForge.net help you be more productive? Does it help you create better code? SHARE THE LOVE, and help us help YOU! Click Here: http://sourceforge.net/donate/ _______________________________________________ List: Openh323gk-users@lists.sourceforge.net Archive: http://sourceforge.net/mailarchive/forum.php?forum_id=8549 Homepage: http://www.gnugk.org/ ------------------------------------------------------- This SF.net email is sponsored by: SF.net Giveback Program. Does SourceForge.net help you be more productive? Does it help you create better code? SHARE THE LOVE, and help us help YOU! Click Here: http://sourceforge.net/donate/ _______________________________________________ List: Openh323gk-users@lists.sourceforge.net Archive: http://sourceforge.net/mailarchive/forum.php?forum_id?49 Homepage: http://www.gnugk.org/
