Hi all, i had a replica 2 gluster 3.12 between S1 and S2 (1 brick per node) geo-replicated to S5 where both S1 and S2 were visible in the geo-replication status and S2 "active" while S1 "passive". I had to replace S1 with S3, so I did an "add-brick replica 3 S3" and then "remove-brick replica 2 S1". Now I have again a replica 2 gluster between S3 and S2 but the geo-replica only show S2 as active and no other peer involved. So it seems S3 does not know about the geo-replica and it is not ready to geo-replicate in case S2 goes down. Here was the original geo-rep status # gluster volume geo-replication status MASTER NODE MASTER VOL MASTER BRICK SLAVE USER SLAVE SLAVE NODE STATUS CRAWL STATUS LAST_SYNCED ---------------------------------------------------------------------------------------------------------------------------------------------------------------- S2 sharedvol /home/sharedvol root ssh://S5::sharedvolslave S5 Passive N/A N/A S1 sharedvol /home/sharedvol root ssh://S5::sharedvolslave S5 Active Changelog Crawl 2018-02-07 10:18:57 Here is the new geo-replication stauts # gluster volume geo-replication status MASTER NODE MASTER VOL MASTER BRICK SLAVE USER SLAVE SLAVE NODE STATUS CRAWL STATUS LAST_SYNCED --------------------------------------------------------------------------------------------------------------------------------------------------------------- S2 sharedvol /home/sharedvol root ssh://S5::sharedvolslave S5 Active Changelog Crawl 2018-02-07 11:48:31 How can I add S3 as a passive node in the geo-replica to S5 ?? Thank you, Stefano _______________________________________________ Gluster-users mailing list Gluster-users@xxxxxxxxxxx http://lists.gluster.org/mailman/listinfo/gluster-users