Re: gluster remove-brick problem

"ghy.83@xxxxxx" <ghy.83@xxxxxx> · Wed, 24 May 2017 16:02:32 +0800

Hi,
	sorry for disturbing you again. I met another problem using GlusterFS.

	I have several machines with CentOs 7.2 and RDMA hardware and software installed. And I can confirm RDMA works well on these machines.
	I yum -y install glusterfs-rdma and glusterfs-server, and started glusterd . Created and started volume using transport type RDMA.

	But I can not mount the glusterfs-server on another client machine. 
	the log error is: W [MSGID: 103071] [rdma.c:1289:gf_rdma_cm_event_handler] 0-data-client-1: cma event RDMA_CM_EVENT_REJECTED, error 8

	In the documentation of gluster, I saw "NOTE: As of now only FUSE client and gNFS server would support RDMA transport.”
	so what is gNFS? How could I do to using RDMA transport type?
	please give me some advice if possible 
	Thanks you very much.

by starshine from beijing, China at 24 June, 2017.

在 2017年5月20日，00:48，Nithya Balachandran <nbalacha@xxxxxxxxxx> 写道：

Hi,
The rebalance could have failed because of any one of several reasons. You would need to check the rebalance log for the volume to figure out why it failed in this case. This should be /var/log/glusterfs/data-rebalance.log on bigdata-dlp-server00.xg01.

I can take a look at the log if you send it across.

Regards,
Nithya

On 19 May 2017 at 13:09, Pranith Kumar Karampuri <pkarampu@xxxxxxxxxx> wrote:
Adding gluster-users, developers who work on distribute module of gluster.

On Fri, May 19, 2017 at 12:58 PM, 郭鸿岩(基础平台部) <guohongyanghy@xxxxxxxxxxxxxxx> wrote:
Hello,

        I am a user of Gluster 3.8 from beijing, China.

        I met a problem.  I added a brick to a volume, but the brick is on the / disk, the same disk with the linux OS.

        So I want to remove it. The volume is of distributed type without replica.

        I use commad: gluster volume remove-brick data server1:/vdata/bricks/data start,

        It is ok. The command is successfully accepted by gluster. But then I check status:  gluster volume remove-brick data server1:/vdata/bricks/data status.

        IT showd:

        Node Rebalanced-files size scanned failures skipped status run time in h:m:s

         --------- ----------- ----------- ----------- ----------- ----------- ------------ ———————

         bigdata-dlp-server00.xg01 0 0Bytes 0 1 0 failed 0:0:0

0 files Scaned, 0 Bytes transfered and 1 failure.

Please give me some advice , How could I do to remove this brick without data loss?

Thank you very much!

best wishes.

by starshine.

-- 
Pranith

_______________________________________________
Gluster-users mailing list
Gluster-users@xxxxxxxxxxx
http://lists.gluster.org/mailman/listinfo/gluster-users