Re: Change underlying brick on node

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 9 August 2016 at 12:23, David Gossage <dgossage@xxxxxxxxxxxxxxxxxx> wrote:
> Since my dev is now on 3.8 and has granular enabled I'm feeling too lazy to
> roll back so will just wait till 3.8.2 is released in few days that fixes
> the bugs mentioned to me and then test this few times on my dev.
>
> Would be nice if I could get to a point where I could have one brick dead
> and doing a full heal and not have every VM pause while shards heal, but I
> may be asking too much when dealing with a rather heavy recovery.


I tested Joe's method with my dev cluster, worked perfectly. The *one*
running VM on it didn't seem to badly affected, but it was already
very slow :)

Thanks Joe.

-- 
Lindsay
_______________________________________________
Gluster-users mailing list
Gluster-users@xxxxxxxxxxx
http://www.gluster.org/mailman/listinfo/gluster-users



[Index of Archives]     [Gluster Development]     [Linux Filesytems Development]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux