On 02/24/2016 09:30 AM, Joe Julian wrote:
After step 6 volume have converted to replicate volume. So if you
create file from mount point it will replicate these file to all
replica set. In your case after step 6 it will replicate only
file(d,e,f) because before step 6 volume was distributed. For
replicating all the file (before step 6) you need to run #gluster
volume heal <volname> full. After executing this command file in both
replica set should be same.
Did that change? It used to trigger the heal crawl automatically when
you changed the replica count.
You needed to manually run full heal for both add-brick and
replace-brick scenarios even in afr-v1. In afr-v2 there is a bug (BZ
1112158) in heal-full but Anuradha's patches are aimed at doing away
with running full heal in both these scenarios as noted in the last 2
comments of the BZ.
Thanks,
_______________________________________________
Gluster-users mailing list
Gluster-users@xxxxxxxxxxx
http://www.gluster.org/mailman/listinfo/gluster-users
