OK, now I'm re-performing tests with rsync + GlusterFS v3.7.6 + the following
patches:
===
Kaleb S KEITHLEY (1):
fuse: use-after-free fix in fuse-bridge, revisited
Pranith Kumar K (1):
mount/fuse: Fix use-after-free crash
Soumya Koduri (3):
gfapi: Fix inode nlookup counts
inode: Retire the inodes from the lru list in inode_table_destroy
upcall: free the xdr* allocations
===
I run rsync from one GlusterFS volume to another. While memory started from
under 100 MiBs, it stalled at around 600 MiBs for source volume and does not
grow further. As for target volume it is ~730 MiBs, and that is why I'm going
to do several rsync rounds to see if it grows more (with no patches bare 3.7.6
could consume more than 20 GiBs).
No "kernel notifier loop terminated" message so far for both volumes.
Will report more in several days. I hope current patches will be incorporated
into 3.7.7.
On пʼятниця, 22 січня 2016 р. 12:53:36 EET Kaleb S. KEITHLEY wrote:
> On 01/22/2016 12:43 PM, Oleksandr Natalenko wrote:
> > On пʼятниця, 22 січня 2016 р. 12:32:01 EET Kaleb S. KEITHLEY wrote:
> >> I presume by this you mean you're not seeing the "kernel notifier loop
> >> terminated" error in your logs.
> >
> > Correct, but only with simple traversing. Have to test under rsync.
>
> Without the patch I'd get "kernel notifier loop terminated" within a few
> minutes of starting I/O. With the patch I haven't seen it in 24 hours
> of beating on it.
>
> >> Hmmm. My system is not leaking. Last 24 hours the RSZ and VSZ are
> >> stable:
> >> http://download.gluster.org/pub/gluster/glusterfs/dynamic-analysis/longev
> >> ity /client.out
> >
> > What ops do you perform on mounted volume? Read, write, stat? Is that
> > 3.7.6 + patches?
>
> I'm running an internally developed I/O load generator written by a guy
> on our perf team.
>
> it does, create, write, read, rename, stat, delete, and more.
_______________________________________________
Gluster-users mailing list
Gluster-users@xxxxxxxxxxx
http://www.gluster.org/mailman/listinfo/gluster-users
