Re: CentOS Freeze with GlusterFS Error

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, Jan 21, 2015 at 10:11:20PM +0530, chamara samarakoon wrote:
> HI All,
> 
> 
> Same error encountered again before trying anything else. So I took screen
> shot  with more details of the incident.

This shows an XFS error. So it can be a problem with XFS, or something
that contributes to it in the XFS path. I would guess it is caused by an
issue on the disk(s) because there is the mentioning of corruption.
However, it could also be bad RAM, or an other hardware component that
is used to access data from the disks. I suggest you take two
approaches:

1. run hardware tests - if the error is detected, contact your HW vendor
2. open a support case with the vendor of the OS and check for updates

Gluster can stress filesystems in ways that are not very common, and
there have been issues found in XFS due to this. Your OS support vendor
should be able to tell you if the latest and related XFS fixes are
included in your kernel.

HTH,
Niels

> 
> 
> ​
> 
> Thank You,
> Chamara
> 
> 
> 
> On Tue, Jan 20, 2015 at 5:33 PM, chamara samarakoon <chthsa123@xxxxxxxxx>
> wrote:
> 
> > HI All,
> >
> > Thank You for valuable feedback , I will test the suggested solutions, and
> > update the thread.
> >
> > Regards,
> > Chamara
> >
> > On Tue, Jan 20, 2015 at 4:17 PM, Deepak Shetty <dpkshetty@xxxxxxxxx>
> > wrote:
> >
> >> In addition, I would also like to add that i do suspect (just my hunch)
> >> that it could be related to multipath.
> >> If you can try without multipath and if it doesn't re-create, i think
> >> that would be a good data point for kernel/OS vendor to debug further.
> >>
> >> my 2 cents again :)
> >>
> >> thanx,
> >> deepak
> >>
> >>
> >> On Tue, Jan 20, 2015 at 2:32 PM, Niels de Vos <ndevos@xxxxxxxxxx> wrote:
> >>
> >>> On Tue, Jan 20, 2015 at 11:55:40AM +0530, Deepak Shetty wrote:
> >>> > What does "Controller" mean, the openstack controller node or somethign
> >>> > else (like HBA ) ?
> >>> > You picture says its SAN but the text says multi-path mount.. SAN would
> >>> > mean block devices, so I am assuming you have redundant block devices
> >>> on
> >>> > the compute host, mkfs'ing it and then creating bricks for gluster ?
> >>> >
> >>> >
> >>> > The stack trace looks like you hit a kernel bug and glusterfsd happens
> >>> to
> >>> > be running on the CPU at the time... my 2 cents
> >>>
> >>> That definitely is a kernel issue. You should contact your OS support
> >>> vendor about this.
> >>>
> >>> The bits you copy/pasted are not sufficient to see what caused it. The
> >>> glusterfsd process is just a casualty of the kernel issue, and it is not
> >>> likely this can be fixed in Gluster. I suspect you need a kernel
> >>> patch/update.
> >>>
> >>> Niels
> >>>
> >>> >
> >>> > thanx,
> >>> > deepak
> >>> >
> >>> > On Tue, Jan 20, 2015 at 11:29 AM, chamara samarakoon <
> >>> chthsa123@xxxxxxxxx>
> >>> > wrote:
> >>> >
> >>> > > Hi All,
> >>> > >
> >>> > >
> >>> > > We have setup Openstack cloud as below. And the
> >>> "/va/lib/nova/instances"
> >>> > > is a Gluster volume.
> >>> > >
> >>> > > CentOS - 6.5
> >>> > > Kernel -  2.6.32-431.29.2.el6.x86_64
> >>> > > GlusterFS - glusterfs 3.5.2 built on Jul 31 2014 18:47:54
> >>> > > OpenStack - RDO using Packstack
> >>> > >
> >>> > >
> >>> > >
> >>> > >
> >>> > > ​
> >>> > >
> >>> > >
> >>> > > Recently Controller node freezes with following error (Which
> >>> required hard
> >>> > > reboot), as a result Gluster volumes on compute node can not reach
> >>> the
> >>> > > controller and due to that all the instances on compute nodes
> >>> become to
> >>> > > read-only status  which causes to restart all instances.
> >>> > >
> >>> > >
> >>> > >
> >>> > >
> >>> > > *BUG: scheduling while atomic : glusterfsd/42725/0xffffffff*
> >>> > > *BUG: unable to handle kernel paging request at 0000000038a60d0a8*
> >>> > > *IP: [<fffffffff81058e5d>] task_rq_lock+0x4d/0xa0*
> >>> > > *PGD 1065525067 PUD 0*
> >>> > > *Oops: 0000 [#1] SMP*
> >>> > > *last sysfs file :
> >>> > >
> >>> /sys/device/pci0000:80/0000:80:02.0/0000:86:00.0/host2/port-2:0/end_device-2:0/target2:0:0/2:0:0:1/state*
> >>> > > *CPU 0*
> >>> > > *Modules linked in : xtconntrack iptable_filter ip_tables
> >>> ipt_REDIRECT
> >>> > > fuse ipv openvswitch vxlan iptable_mangle *
> >>> > >
> >>> > > Please advice on above incident , also feedback on the Openstack +
> >>> > > GlusterFS setup is appreciated.
> >>> > >
> >>> > > Thank You,
> >>> > > Chamara
> >>> > >
> >>> > >
> >>> > > _______________________________________________
> >>> > > Gluster-users mailing list
> >>> > > Gluster-users@xxxxxxxxxxx
> >>> > > http://www.gluster.org/mailman/listinfo/gluster-users
> >>> > >
> >>>
> >>>
> >>>
> >>> > _______________________________________________
> >>> > Gluster-users mailing list
> >>> > Gluster-users@xxxxxxxxxxx
> >>> > http://www.gluster.org/mailman/listinfo/gluster-users
> >>>
> >>>
> >>
> >
> >
> > --
> > chthsa
> >
> 
> 
> 
> -- 
> chthsa


Attachment: pgpiyikEFEL4b.pgp
Description: PGP signature

_______________________________________________
Gluster-users mailing list
Gluster-users@xxxxxxxxxxx
http://www.gluster.org/mailman/listinfo/gluster-users

[Index of Archives]     [Gluster Development]     [Linux Filesytems Development]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux