Hi Taira,
Thanks for the updates...I want to use gluster with Ovirt...would you mind to more elaborate this (- If you use only gluster ative protocol then you don't need to configure HA with keepalived.)
Thanks,
Punit
On Mon, Aug 18, 2014 at 1:00 PM, TAIRA Hajime <htaira@xxxxxxxxxxx> wrote:
Hi, Punit
Best practices are:
- Use RAID6 or RAID1+0 array for brick
- Choose Replicated-Distributed volume type
- If you use only gluster ative protocol then you don't need to configure HA with keepalived.
Best regards,Taira2014-08-15 16:39 GMT+09:00 Punit Dambiwal <hypunit@xxxxxxxxx>:Hi,I want to use gluster distributed replicate storage with 4 nodes with the below configuration :-
- 4 x Quanta STRATOS S210-X22RQ
- 4 x 12 x 512 GB , 2.5″ SSD (front, hot swappable main storage)
- 4 x 2 x 128 GB, 2’5″ SSD (rear, hot swappable os drives, awesome feature!)
- 2 x quality stacked switches (with one leg of each bond device out to each switch)
- IPMI: For Fencing Ovirt.
I want to use this setup in ovirt...I seek your help to best utilize the storage with redundancy(even one node failure or any HDD failure) ??Do i need to use the HW RAID also...it seems the gluster replication can do the same...any advise ??Also i want it to be high available...if any node goes down the data can be accessible...please refer any good document for HA with keepalived or others ??Thanks,Punit_______________________________________________
Gluster-users mailing list
Gluster-users@xxxxxxxxxxx
http://supercolony.gluster.org/mailman/listinfo/gluster-users
_______________________________________________
Gluster-users mailing list
Gluster-users@xxxxxxxxxxx
http://supercolony.gluster.org/mailman/listinfo/gluster-users
_______________________________________________ Gluster-users mailing list Gluster-users@xxxxxxxxxxx http://supercolony.gluster.org/mailman/listinfo/gluster-users
