On 25.09.2013 20:15, Nux! wrote: >> "Peer rejected" is seen if there is a volume configuration mismatch >> between peers. Can you check if there is a mismatch in volume >> configuration between the two sets of peers? > > I have checked the volumes "info" files following Krishnan's advice > and they seem to have the same data, though oddly not exactly in the > same place, e.g. some have auth.allow above rpc.auth-allow and it's > counterpart info files from other servers have it the other way > around, but the values are identical. Aren't these files supposed to > be 100% the same? > > Other than this, the volume files on all servers have port=0 for the > bricks that are on the "rejected" peers. > > So it's hard to say which is the "right" set of servers and on which > I should execute the instructions from > http://www.gluster.org/community/documentation/index.php/Resolving_Peer_Rejected > > I'm afraid not to make this even a bigger disaster. > > Suggestions? Anyone? Should I just proceed with the wiki's instructions? -- Sent from the Delta quadrant using Borg technology! Nux! www.nux.ro
