Tools for the admin

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 07/21/2011 05:07 PM, Whit Blauvelt wrote:
> On Thu, Jul 14, 2011 at 12:15:00AM -0400, Joe Landman wrote:
>
>> Tool #2: scan_gluster.pl
>
> Joe,
>
> Thanks for this contributions.
>
> scan_gluster.pl seems to depend on File::ExtAttr, which when I try to
> install it from cpan to Perl v5.10.1 fails at the "make" step for reasons
> cpan leaves unclear. Is there some prerequisite that might not be properly
> requested?
>
> Looking at this now because I just had a simple Gluster replication setup
> blow up in a nonobvious way. Not obvious from the logs anyhow. It may well
> be because I switched it from 3.1.3 to 3.1.5 a few days back. Anyway, it
> gives me a good excuse to learn how to diagnose a good failure, so I thought
> I'd start by seeing what your tools can show.
>

Depending upon distro, you would need libattr, attr-dev, etc.  Sadly, 
there is little/no consistency in naming these.

If this turns out to be an issue, I'll see if I can code around it, but 
doing a sub process for each file would be seriously expensive for even 
reasonable sized file systems.

> Best,
> Whit


-- 
Joseph Landman, Ph.D
Founder and CEO
Scalable Informatics, Inc.
email: landman at scalableinformatics.com
web  : http://scalableinformatics.com
        http://scalableinformatics.com/sicluster
phone: +1 734 786 8423 x121
fax  : +1 866 888 3112
cell : +1 734 612 4615


[Index of Archives]     [Gluster Development]     [Linux Filesytems Development]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux