On 07/22/2014 03:07 PM, Atin Mukherjee wrote:
On 07/22/2014 03:01 PM, Lalatendu Mohanty wrote:
I am trying to compile master for doing a fresh Coverity run. But
Coverity is complaining that source is not compiled fully. When I did
the same manually, I saw "make" is returning very less output compared
to past. I have copied the make output (along with autogen and
configure) in http://ur1.ca/ht05t .
I will appreciate any help on this.
Below is the error returned from Coverity:
/Your request for analysis of GlusterFS is failed.
Analysis status: FAILURE
Please fix the error and upload the build again.
Could be because of the lcmockery lib missing at the missing?
Nope, the below cmockery packages were installed during the compilation.
Otherwise it would have failed with error.
cmockery2-1.3.7-1.fc19.x86_64
cmockery2-devel-1.3.7-1.fc19.x86_64
Error details:
Build uploaded has not been compiled fully. Please fix any compilation error. You may have to run bin/cov-configure as described in the article on Coverity Community. Last few lines of cov-int/build-log.txt should indicate 85% or more compilation units ready for analysis
For more detail explanation on the error, please check: //https://communities.coverity.com/message/4820//
/
Thanks,
Lala
_______________________________________________
Gluster-devel mailing list
Gluster-devel@xxxxxxxxxxx
http://supercolony.gluster.org/mailman/listinfo/gluster-devel
_______________________________________________
Gluster-devel mailing list
Gluster-devel@xxxxxxxxxxx
http://supercolony.gluster.org/mailman/listinfo/gluster-devel
_______________________________________________
Gluster-devel mailing list
Gluster-devel@xxxxxxxxxxx
http://supercolony.gluster.org/mailman/listinfo/gluster-devel
