Hi Avand:
Thank you for looking at this.
*Spec file for Server:*
volume brick
type storage/posix # POSIX FS translator
option directory /home/export # Export this directory
end-volume
volume server
type protocol/server
option transport-type tcp/server # For TCP/IP transport
subvolumes brick
option auth.ip.brick.allow * # Allow access to "brick" volume
end-volume
*Spec file for Client:
*volume client
type protocol/client
option transport-type tcp/client # for TCP/IP transport
option remote-host 192.168.1.225 # IP address of the remote brick*
* option remote-subvolume brick # name of the remote volume
end-volume
*
Commands used to start glusterfs on the Server:
*/usr/local/sbin/glusterfsd*
*
*Command used to start glusterfs on the Client:*
/usr/local/sbin/glusterfs -s 192.168.1.225 /mnt/point
(I tried to follow the "Getting Started with GlusterFS" document from
the wiki as close as possible)
thanks,
Paul Jochum
Anand Avati wrote:
Paul,
can you please post your volume spec files and the command line with
which you are trying to start glusterfs?
avati
2007/9/7, Paul Jochum < jochum@xxxxxxxxxxxxxxxxxx
<mailto:jochum@xxxxxxxxxxxxxxxxxx>>:
Hi all:
I am trying out glusterfs 1.3.1 (from the download page), for the
first time. It compiled and installed fine. I am running a simple
configuration of one client and one brick, using the supplied example
/etc/glusterfs vol files (just changed the address in the client's
vol
file), and seems to run on the server. When I try to run it on the
client, it immediately fails with the message:
glusterfs: could not open specfile
On the client's log file, I am seeing:
2007-09-06 23:15:04 E [ protocol.c:253:gf_block_unserialize_transport]
trans: EOF from peer (192.168.1.225:6996 <http://192.168.1.225:6996>)
On the server's log file, I am seeing:
2007-09-06 23:14:39 C [tcp.c:81:tcp_disconnect] server: connection
disconnected
2007-09-06 23:14:39 E [server-protocol.c:197:generic_reply] server:
transport_writev failed
I can ping, and ssh between the two hosts. I have disabled
iptables
and ip6tables on the server and client.
So, I assume that I am missing something basic here, but don't
know
where to start looking. Any suggestions?
thanks,
Paul Jochum
_______________________________________________
Gluster-devel mailing list
Gluster-devel@xxxxxxxxxx <mailto:Gluster-devel@xxxxxxxxxx>
http://lists.nongnu.org/mailman/listinfo/gluster-devel
<http://lists.nongnu.org/mailman/listinfo/gluster-devel>
--
It always takes longer than you expect, even when you take into
account Hofstadter's Law.
-- Hofstadter's Law
