Hi, On Fri, 7 Dec 2007, Daniel Berlin wrote: > On 12/7/07, Giovanni Bajo <rasky@xxxxxxxxxxx> wrote: > > On Fri, 2007-12-07 at 14:14 -0800, Jakub Narebski wrote: > > > > > > >> Is SHA a significant portion of the compute during these > > > > >> repacks? I should run oprofile... > > > > > SHA1 is almost totally insignificant on x86. It hardly shows up. > > > > > But we have a good optimized version there. zlib tends to be a > > > > > lot more noticeable (especially the *uncompression*: it may be > > > > > faster than compression, but it's done _so_ much more that it > > > > > totally dominates). > > > > > > > > Have you considered alternatives, like: > > > > http://www.oberhumer.com/opensource/ucl/ > > > > > > <quote> > > > As compared to LZO, the UCL algorithms achieve a better > > > compression ratio but *decompression* is a little bit slower. See > > > below for some rough timings. > > > </quote> > > > > > > It is uncompression speed that is more important, because it is used > > > much more often. > > > > I know, but the point is not what is the fastestest, but if it's fast > > enough to get off the profiles. I think UCL is fast enough since it's > > still times faster than zlib. Anyway, LZO is GPL too, so why not > > considering it too. They are good libraries. > > > At worst, you could also use fastlz (www.fastlz.org), which is faster > than all of these by a factor of 4 (and compression wise, is actually > sometimes better, sometimes worse, than LZO). fastLZ is awfully short on details when it comes to a comparison of the resulting file sizes. The only result I saw was that for the (single) example they chose, compressed size was 470MB as opposed to 361MB for zip's _fastest_ mode. Really, that's not acceptable for me in the context of git. Besides, if you change the compression algorithm you will have to add support for legacy clients to _recompress_ with libz. Which most likely would make Sisyphos grin watching them servers. Ciao, Dscho - To unsubscribe from this list: send the line "unsubscribe git" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
