From: Johannes Schindelin <johannes.schindelin@xxxxxx> In the web UI of GitHub workflows, failed runs are presented with the job step that failed auto-expanded. In the current setup, this is not helpful at all because that shows only the output of `prove`, which says which test failed, but not in what way. What would help understand the reader what went wrong is the verbose test output of the failed test. The logs of the failed runs do contain that verbose test output, but it is shown in the _next_ step (which is marked as succeeding, and is therefore _not_ auto-expanded). Anyone not intimately familiar with this would completely miss the verbose test output, being left mostly puzzled with the test failures. We are about to show the failed test cases' output in the _same_ step, so that the user has a much easier time to figure out what was going wrong. But first, we must partially revert the change that tried to improve the CI runs by combining the `Makefile` targets to build into a single `make` invocation. That might have sounded like a good idea at the time, but it does make it rather impossible for the CI script to determine whether the _build_ failed, or the _tests_. If the tests were run at all, that is. So let's go back to calling `make` for the build, and call `make test` separately so that we can easily detect that _that_ invocation failed, and react appropriately. Signed-off-by: Johannes Schindelin <johannes.schindelin@xxxxxx> --- ci/run-build-and-tests.sh | 10 +++++++--- 1 file changed, 7 insertions(+), 3 deletions(-) diff --git a/ci/run-build-and-tests.sh b/ci/run-build-and-tests.sh index 280dda7d285..b70373c172f 100755 --- a/ci/run-build-and-tests.sh +++ b/ci/run-build-and-tests.sh @@ -10,7 +10,7 @@ windows*) cmd //c mklink //j t\\.prove "$(cygpath -aw "$cache_dir/.prove")";; *) ln -s "$cache_dir/.prove" t/.prove;; esac -export MAKE_TARGETS="all test" +run_tests=t case "$jobname" in linux-gcc) @@ -41,14 +41,18 @@ pedantic) # Don't run the tests; we only care about whether Git can be # built. export DEVOPTS=pedantic - export MAKE_TARGETS=all + run_tests= ;; esac # Any new "test" targets should not go after this "make", but should # adjust $MAKE_TARGETS. Otherwise compilation-only targets above will # start running tests. -make $MAKE_TARGETS +make +if test -n "$run_tests" +then + make test +fi check_unignored_build_artifacts save_good_tree -- gitgitgadget
