Reword the discussion of the built-in userdiff patterns to make it more natural to precede it with a discussion about the semantics of pattern matching, instead of assuming that it follows right after the "diff.tex.xfuncname" example which now immediately precedes it. This will make a follow-up commit smaller. Helped-by: Eric Sunshine <sunshine@xxxxxxxxxxxxxx> Signed-off-by: Ævar Arnfjörð Bjarmason <avarab@xxxxxxxxx> --- Documentation/gitattributes.txt | 16 +++++++++++----- 1 file changed, 11 insertions(+), 5 deletions(-) diff --git a/Documentation/gitattributes.txt b/Documentation/gitattributes.txt index e84e104f932..62c1147ba97 100644 --- a/Documentation/gitattributes.txt +++ b/Documentation/gitattributes.txt @@ -794,11 +794,17 @@ backslashes; the pattern above picks a line that begins with a backslash, and zero or more occurrences of `sub` followed by `section` followed by open brace, to the end of line. -There are a few built-in patterns to make this easier, and `tex` -is one of them, so you do not have to write the above in your -configuration file (you still need to enable this with the -attribute mechanism, via `.gitattributes`). The following built in -patterns are available: +There are built-in patterns shipped as part of git itself. A more +advanced version of the `tex` pattern discussed above is one of them. + +For built-in patterns, you do not need `diff.<lang>.xfuncname` in your +configuration file as discussed above, but if present, it will +override a built-in pattern. + +Nevertheless, you need to enable built-in patterns via .gitattributes` +for the pattern to take effect. + +The following built-in patterns are available: - `ada` suitable for source code in the Ada language. -- 2.30.0.284.gd98b1dd5eaa7
