Re: [PATCH/RFC] rebase: make resolve message clearer for inexperienced users

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 24/07/17 21:53, Junio C Hamano wrote:
Phillip Wood <phillip.wood@xxxxxxxxxxxx> writes:

git rebase --continue requiring one to git add first confuses/annoys me
too. I started a patch to autostage unstaged changes if they don't
contain conflict markers a couple of weeks ago, I'll clean it up and
post it later this week.

As long as "git rebase" will keep refusing to start in a working
tree with dirty files and/or index, this could be a good change.

But people _may_ be annoyed because they expect "--continue" to
remind them that some conflicts are not concluded with an explicit
"git add", and they would even feel that you made the command unsafe
if "--continue" just goes ahead by auto-adding their change that is
still work-in-progress.  Lack of conflict markers is not a sign that
a file is fully resolved (which they are used to signal by "git
add", and they do so per set of paths).

Thanks for your comments, I've tried to address them in the message with the patches I sent earlier today [1]. In summary autostaging is opt-in and the conflict marker check isn't perfect but it's better than nothing and covers an important case where the user has simply overlooked a conflict.

I also find it confusing that it asks me to edit the commit message for
picks, fixups and non-final squashes after conflicts. I can see that
perhaps one might want to amend the message to reflect any changes that
were made while resolving the conflicts but I've never had too. I'd
rather be able to pass --edit to rebase --continue if I needed to edit
the message in those cases. Looking through the code I think it would
require saving some extra state when rebase bails out on conflicts so
rebase --continue could tell if it should be asking the user to amend
the message.

This is disruptive if done without a careful transition plan and
you'll annoy existing users who expect to be able to edit by
default.  Especially since "rebase" keeps going and potentially
rebuild many commits on top, by the time they realize the mistake of
not passing "--edit", it is too late and they will hate you for
forcing them rebase many commits again.

I agree, I was imagining the new behaviour would be opt in via a config variable. Then if in the future there is a consensus to enable the new behaviour by default there would be a transition phase where users of the old behaviour would get a message telling that the behaviour is going to change in the future and what value to set the config variable to in order to keep the old behaviour if that's what they want.

If these suggestions above were given while "rebase -i" was
developed, it might have made the end-user experience a better one
than what it currently is, but transitioning after the current
behaviour has long been established makes it much harder.

Sadly I didn't even know git existed at the time rebase was first added.

Best Wishes

Phillip


[1] https://public-inbox.org/git/20170726102720.15274-2-phillip.wood@xxxxxxxxxxxx/T/#u




[Index of Archives]     [Linux Kernel Development]     [Gcc Help]     [IETF Annouce]     [DCCP]     [Netdev]     [Networking]     [Security]     [V4L]     [Bugtraq]     [Yosemite]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux SCSI]     [Fedora Users]

  Powered by Linux