> > On 07/05/16 15:38, Øyvind Kolås wrote:
> >> I've pushed code to GEGL master that makes the resamplers called
> >> "linear" and "cubic" do a tiny bit more than just interpolation.
> On Mon, May 9, 2016 at 12:11 PM, Karl Günter Wünsch wrote:
> > The more you change the default behavior of existing filters the more it
> > makes the use of GIMP impossible in a setup where you build up a
> > workflow... It's bad enough to outright drop the previously available
> > scaling algorithm but to tinker and thus in some cases invalidate
> > existing workflows without the user being made aware of it is ridiculous
> > for a tool like the GIMP...
Øyvind Kolås writes:
> This was a fix for the 2.9 series - any releases of 2.9 thus far have
> been development snapshots and you shouldn't be establishing
> unchangable workflows based on the behavior of development snapshots.
As someone who down-scales a lot (and who expects workflow and
defaults to change now and then when using development releases), I
want to thank Øyvind for the new code. Downscaling with Cubic looks
much better now (compared to the previous 2.9 behavior), and is much
faster than LoHalo/NoHalo. Good stuff!
...Akkana
_______________________________________________
gimp-developer-list mailing list
List address: gimp-developer-list@xxxxxxxxx
List membership: https://mail.gnome.org/mailman/listinfo/gimp-developer-list
List archives: https://mail.gnome.org/archives/gimp-developer-list
