On 8 May 2011 13:14, Jonathan Wakely wrote: > On 8 May 2011 11:39, JF MARQUET (Y) wrote: >> High >> >> I am not an expert...! But I try to install GCC on a small server >> ( >> a "Q-ONE" from Memup Corrporation, >> the uname of this server is : Linux Q-ONE 2.6.15 #221 Wed Jun 10 14:43:33 >> KST 2009 armv4l unknown >> its shell is transferred to a Busybox : BusyBox v1.00-rc3 >> (2009.04.17-08:49+0000) Built-in shell (ash) >> >> Afetr GCC installation, I can try to install some other simpler software.... >> ) >> >> After 1 full day with constant failures, I perhaps understand that I cannot >> install GCC on a system with does not have already a minimal compiler >> installed...... > > Correct. That should be clear from the first item listed at > http://gcc.gnu.org/install/prerequisites.html > > >> Then I hope it is possible to make a "remote installation" ? >> This idea because I also have a much better equipped LINUX PC connected to >> this server (built from UBUNTU distribution, and having GCC installed) >> >> Is it possible to "run" the installation of GCC on my server from my PC ? >> (using the parameter "target", may be ? What is the grammar for that ? > > You need a cross-compiler, which will run on your PC but generate code > for your arm box. > > You don't just run gcc with a target option, it needs to be an > entirely separate installation of gcc and it will only generate code > for arm. > > You can probably install a cross-compiler from your distro's package > manager, look for a package called arm-gcc or arm-linux-gcc or > something like that. Alternatively you can build gcc on your PC and then copy the resulting compiler to your arm box. Maybe that's what you meant by remote installation - but you don't "run the installation ... from your PC", you build gcc on your PC, then when that's finished you copy the gcc files to the arm server. That would allow you to run the compiler on the arm box itself, instead of running it on the PC. I think building gcc like that would be done by configuring with --host set to some suitable value for your arm box (I'm not sure what that would be for your case.)
