I have a btrfs config where I specifically exclude raid56 testing, and
this resulted in btrfs/011 failing with an inconsistent file system.
This happens because the last test we run does a btrfs device replace of
the $SCRATCH_DEV, leaving it with no valid file system. We then skip
the remaining profiles and exit, but then we go to check the device on
$SCRATCH_DEV and it fails because there is no file system.
Fix this to re-make the scratch device if we skip any of the raid
profiles. This only happens in the case of some idiot user configuring
their testing in a special way, in normal runs of this test we'll never
re-make the fs.
Signed-off-by: Josef Bacik <josef@xxxxxxxxxxxxxx>
---
tests/btrfs/011 | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/tests/btrfs/011 b/tests/btrfs/011
index d8b5a978..b8c14f3b 100755
--- a/tests/btrfs/011
+++ b/tests/btrfs/011
@@ -257,6 +257,12 @@ for t in "-m single -d single:1 no 64" \
workout_option=${t#*:}
if [[ "${_btrfs_profile_configs[@]}" =~ "${mkfs_option/ -M}"( |$) ]]; then
workout "$mkfs_option" $workout_option
+ else
+ # If we have limited the profile configs we could leave
+ # $SCRATCH_DEV in an inconsistent state (because it was
+ # replaced), so mkfs the scratch device to make sure we don't
+ # trip the fs check at the end.
+ _scratch_mkfs > /dev/null 2>&1
fi
done
--
2.43.0
