on 2021/10/24 20:05, Zorro Lang wrote: > Sometimes g/648 fail to unmount dmerror with this error: > > umount: /mnt/xfstests/scratch: target is busy. > > Even worse, it will cause all later test cases fail as: > > mount: bad usage > Try 'mount --help' for more information. > check: failed to mount $SCRATCH_DEV using specified options > Interrupted! > > So we shouldn't _fail directly if dmerror_unmount fails, use a while > loop to try to unmount it enough times. I also met EBUSY error when testing other cases(I need to filter about 60 cases for this reason and do signle test for them) that using dmerror or dmflakey. Can we add a umount_api for dmerror/dmflakey that use a while loop to umount during enough time in xfstest layer? Best Regards Yang Xu > > Signed-off-by: Zorro Lang<zlang@xxxxxxxxxx> > --- > > As Darrick's review point, V2 brings the "iteration XXX scratch > unmount failed" _fail back. > > Thanks, > Zorro > > tests/generic/648 | 18 ++++++++++++++++-- > 1 file changed, 16 insertions(+), 2 deletions(-) > > diff --git a/tests/generic/648 b/tests/generic/648 > index 83dd111d..e5c743c5 100755 > --- a/tests/generic/648 > +++ b/tests/generic/648 > @@ -104,7 +104,7 @@ for i in $(seq 1 $((25 * TIME_FACTOR)) ); do > wait> /dev/null 2>&1 > ps -e | grep fsstress> /dev/null 2>&1 > done > - for ((i = 0; i< 10; i++)); do > + for ((j = 0; j< 10; j++)); do > test -e "$snap_aliveflag" || break > sleep 1 > done > @@ -112,7 +112,21 @@ for i in $(seq 1 $((25 * TIME_FACTOR)) ); do > # Mount again to replay log after loading working table, so we have a > # consistent fs after test. > $UMOUNT_PROG $loopmnt > - _dmerror_unmount || _fail "iteration $i scratch unmount failed" > + is_unmounted=1 > + # We must unmount dmerror at here, or whole later testing will crash. > + # So try to umount enough times, before we have no choice. > + for ((j = 0; j< 100; j++)); do > + sleep 1 > + _dmerror_unmount> $tmp.unmount.err 2>&1 > + if [ $? -eq 0 ];then > + is_unmounted=0 > + break > + fi > + done > + if [ $is_unmounted -ne 0 ];then > + cat $tmp.unmount.err > + _fail "iteration $i scratch unmount failed" > + fi > _dmerror_load_working_table > if ! _dmerror_mount; then > _metadump_dev $DMERROR_DEV $seqres.scratch.$i.md
