Boris, actually I used your config. The same config as I used for -rc6 build. Works just fine for me - but I did not try booting with 3.4.1, only with xen-unstable. Mark Boris Derzhavets wrote: > Mark, > Could you share your .config for JF's 2.6.31-rc8 which loads under Xen Unstable. > Looks like i miss some point tuning kernel. > > Thanks. > Boris. > > --- On Fri, 9/4/09, Boris Derzhavets <bderzhavets@xxxxxxxxx> wrote: > > From: Boris Derzhavets <bderzhavets@xxxxxxxxx> > Subject: [Xen-devel] Re: Xorg on JF 2.6.31-rc8 with xen 3.5 unstable > To: fedora-xen@xxxxxxxxxx, "Mark Schloesser" <mark.schloesser@xxxxxxxxxxxxxx> > Cc: xen-devel@xxxxxxxxxxxxxxxxxxx > Date: Friday, September 4, 2009, 2:02 PM > > I did "git pull" , built 2.6.31-c8 kernel with Xen Dom0 support. > However, attempt to load kernel under Xen 3.4.1 drops > into stack trace and hangs on both F11 and Ubuntu 9.10. > Old 2.6.31-rc6's .config file has been used without any changes. > I can't set up serial console in meantime. > > Boris > > --- On Fri, 9/4/09, Mark Schloesser <mark.schloesser@xxxxxxxxxxxxxx> wrote: > > From: Mark Schloesser <mark.schloesser@xxxxxxxxxxxxxx> > Subject: Xorg on JF 2.6.31-rc8 with xen 3.5 unstable > To: fedora-xen@xxxxxxxxxx > Date: Friday, September 4, 2009, 10:26 AM > > Hey guys, > > I sadly had no luck fixing my X problem. The system seems to run fine > and as the subject says I moved > from 3.4.1-3 to xen-unstable. As I am > already doing fairly bleeding-edge stuff here I thought this would > probably make most sense. > > As I only have an nvs290 gfx card available right now I can't check if > this is the problem. But I'll try to get my hands on some other cards > for next week. > > Today I read through a lot of mailing list archives and PDFs trying to > dig deeper into the IOMMU/PCI passthrough stuff and I want to give the > graphics passthrough situation a shot myself. Sadly it is very confusing > to read about the different setups and hardware environments with both > positive and negative results. Also the patchsets and versions everybody > is talking about do not make it any easier :) > > My current questions would be: > - is the combination of JF git kernel with xen-unstable the right way to > go for this setup? Or should I perhaps use older xen version and apply > some patchset? I think some of those > patches were applied in > xen-unstable already but I am not quite sure... > > - does anyone have hints or clarification regarding the Xorg problem on > dom0? As I said there are no eye-catching log entries or errors except > the Xorg backtrace at the end of the log file (posted to list before). > This happens regardless of which driver I enable (vesa/nv/nouveau). The > nvidia binary driver compiles without problems and seems to come up but > only gives me a black screen and also locks the vtys. > > > Thanks to the great help, reports and instructions Boris and others! > > Mark > > > -----Inline Attachment Follows----- > > -- > Fedora-xen mailing list > Fedora-xen@xxxxxxxxxx > https://www.redhat.com/mailman/listinfo/fedora-xen > > > > > > > -----Inline Attachment Follows----- > > _______________________________________________ > Xen-devel mailing list > Xen-devel@xxxxxxxxxxxxxxxxxxx > http://lists.xensource.com/xen-devel > > > > > > > ------------------------------------------------------------------------ > > _______________________________________________ > Xen-devel mailing list > Xen-devel@xxxxxxxxxxxxxxxxxxx > http://lists.xensource.com/xen-devel
Attachment:
signature.asc
Description: OpenPGP digital signature
-- Fedora-xen mailing list Fedora-xen@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/fedora-xen
