Hi, (Sorry for the really long question :P) I was trying to do the VM migration with Fedora Core XEN. The configuration is like this: Source Host: Host1, OS is Fedora Core 6 Destination Host: Host2, OS is Fedora Core 6 Both of the two hosts are of the same hardware architecture. I have installed a XEN guest, XEN1, at Host1. The operating system of XEN1 is also Fedora Core 6. What I wanted to do is to migrate XEN1 from Host1 to Host2. Before doing the migration, the xend could be started successfully, and I can use the system tool, Virtual Machine Manager, of Fedora Core to see the information of all domains. To enable the migration, (1) First, I changed the configuration file, /etc/xen/xend-config.sxp at HOST1, change is as following: #(xend-unix-server yes) (xend-relocation-server yes) (xend-relocation-port 8002) (xend-relocation-address ? ?) (xend-relocation-hosts-allow host2) #(xend-relocation-hosts-allow '^localhost$ ^localhost\\.localdomain$') /etc/xen/xend-config.sxp at HOST2, change is as following: #(xend-unix-server yes) (xend-relocation-server yes) (xend-relocation-port 8002) (xend-relocation-address ? ?) (xend-relocation-hosts-allow host1) #(xend-relocation-hosts-allow '^localhost$ ^localhost\\.localdomain$') ?? Should I use (xend-relocation-hosts-allow '') instead of (xend-relocation-hosts-allow host1) ? Then I restart the xend: "service xend restart" However the system tool, Virtual Machine Manager,of Fedora Core, can't run. After I click the "connect", the following error msg appears: Unable to open a connection to the Xen Hypervisor/daemon Verify that: -A Xen host kernel was booted -The Xen service has been started It's weird. Because I can use "service xend status" to show that xend is running and use "xm list" to show that Domain-0 is running. But Virtual Machine Manager doesn't work. ?? (2) Second, configure NFS to export a shared storage via NFS. The shared storage can be accessed from HOST1 and HOST2. (3) Third, run "xm create -c XEN1" However, Some error messages appear, they are as follows: Using config file "/etc/xen/xen1". Going to boot Fedora Core (2.6.19-1.2911.6.5.fc6xen) kernel: /vmlinuz-2.6.19-1.2911.6.5.fc6xen initrd: /initrd-2.6.19-1.2911.6.5.fc6xen.img Started domain xen1 PCI: Fatal: No config space access function found rtc: IRQ 8 is not free. i8042.c: No controller found. What is the reason of this problem? And "xm list" shows that XEN1 is there. ?? Since the guest can't be started. I shutdown it. And following msg appears: hcid[1318]: segfault at 00002aac0123b8a0 rip 00002aaaaacec014 rsp 00007fff7d5f9010 error 4 IPv6 over IPv4 tunneling driver md: stopping all md devices. System halted. (4) To enable the migration, do I need to change the security level and firewall, for example, the firewall should be enabled or disabled, and add any trusted ports besides the default ones. The SELinux should be enforced, permited, or disabled? What changes do I need to make at the source and destination hosts? Thanks for you time. Best Wishes Angel -- Fedora-xen mailing list Fedora-xen@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/fedora-xen
