Thank you, I get the impression that httpd is listening on port 443
but not port 80 and that is the problem:
443 is https port, so this is most probably your configuration problem.
The issue seems to involve how I have my DNS and dhcpd set up. I use
dhcp to assign specific ip addresses to specific host names. However I'm
not doing a very good job of it with my laptop. I don't know how to get
the same IP address (192.168.1.46) assigned to both my wired and
wireless network adapters (which have different MAC addresses of
course), so that regardless of which adapter I am using at the moment, I
can get httpd to work.
If I code this in httpd.conf:
Listen deafeng3.signtype.info:80 and then restart httpd, I will get this
output:
[root@deafeng3 conf]# service httpd restart
Stopping httpd: [ OK ]
Starting httpd: (99)Cannot assign requested address: make_sock: could
not bind to address 192.168.1.46:80
no listening sockets available, shutting down
Unable to open logs
[FAILED]
If I code this in httpd.conf:
Listen 192.168.1.48:80
Then it works fine if I open Firefox and browse to http://192.168.1.48/
but
not if I browse to http://localhost/. Maybe for this I need to specify
an additional 'Listen' entry, 'Listen localhost:80' or 'Listen
127.0.0.1:80'.
The real issue is I would like to have both my network adapters
recognized as representing the same hostname on dhcpd, and so assign it
the same IP address. I can see that can be problematic. So perhaps it
would be better to have httpd recognize either IP address as being for
the same hostname.
Here is what ifconfig says:
[root@deafeng3 conf]# ifconfig
eth0 Link encap:Ethernet HWaddr 00:21:70:C1:AA:79
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Memory:f6fe0000-f7000000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:24 errors:0 dropped:0 overruns:0 frame:0
TX packets:24 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2004 (1.9 KiB) TX bytes:2004 (1.9 KiB)
virbr0 Link encap:Ethernet HWaddr 86:2B:40:DA:C2:A4
inet addr:192.168.122.1 Bcast:192.168.122.255 Mask:255.255.255.0
inet6 addr: fe80::842b:40ff:feda:c2a4/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:34 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:6380 (6.2 KiB)
wlan0 Link encap:Ethernet HWaddr 00:21:6A:0C:7D:FE
inet addr:192.168.1.48 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::221:6aff:fe0c:7dfe/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4331 errors:0 dropped:0 overruns:0 frame:0
TX packets:2218 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1715481 (1.6 MiB) TX bytes:242937 (237.2 KiB)
wmaster0 Link encap:UNSPEC HWaddr
00-21-6A-0C-7D-FE-D0-FA-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
I guess this is a new laptop and networking wrinkle that I need to deal
with.
Bob
--
fedora-test-list mailing list
fedora-test-list@xxxxxxxxxx
To unsubscribe:
https://www.redhat.com/mailman/listinfo/fedora-test-list
