This always used to work. Plugging in this sansa device would open the plasma, showing the device. Now, nothing happens. Log says: Dec 31 17:34:38 nbecker1 kernel: usb 5-2: USB disconnect, address 4 Dec 31 17:34:45 nbecker1 kernel: usb 2-2: new high speed USB device using ehci_hcd and address 6 Dec 31 17:34:45 nbecker1 kernel: ehci_hcd 0000:00:1d.7: port 2 reset error -110 Dec 31 17:34:45 nbecker1 kernel: hub 2-0:1.0: hub_port_status failed (err = -32) Dec 31 17:34:45 nbecker1 kernel: hub 2-0:1.0: unable to enumerate USB device on port 2 Dec 31 17:34:46 nbecker1 kernel: usb 5-2: new full speed USB device using uhci_hcd and address 5 Dec 31 17:34:46 nbecker1 kernel: usb 5-2: not running at top speed; connect to a high speed hub Dec 31 17:34:46 nbecker1 kernel: usb 5-2: configuration #1 chosen from 1 choice Dec 31 17:34:46 nbecker1 kernel: scsi7 : SCSI emulation for USB Mass Storage devices Dec 31 17:34:46 nbecker1 kernel: usb 5-2: New USB device found, idVendor=0781, idProduct=7432 Dec 31 17:34:46 nbecker1 kernel: usb 5-2: New USB device strings: Mfr=6, Product=7, SerialNumber=8 Dec 31 17:34:46 nbecker1 kernel: usb 5-2: Product: SanDisk Sansa Clip Dec 31 17:34:46 nbecker1 kernel: usb 5-2: Manufacturer: SanDisk Dec 31 17:34:46 nbecker1 kernel: usb 5-2: SerialNumber: F4FEF9132030B5910000000000000000 -- fedora-test-list mailing list fedora-test-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-test-list
