On Sat, May 26, 2007 at 14:16:28 -0500, Bruno Wolff III <bruno@xxxxxxxx> wrote: > > I am seeing some annoying stuff which display resolution. I have a TNT2 > card that appears to be using the nv driver and a sync master 1100p > monitor. After the upgrade it was using a different resolution than > before. The name displayed in the display hardware menu didn't match > the name in the drop down menu for the same device. When I switched to > the name I could pick and rebooted it came up in a mode that wasn't usable > (the display had color, but it wasn't in the right places). I tried removing > the xorg.conf file and letting it auto detect again and it came up unusable > again. So I switched to the backup config file. I looked through the xorg log and it looks like it is picking up reasonable possible modes for the monitor from direct probing. However the modes I would like are being rejected when checked against the video card as either "width too large for virtual size" or "height too large for virtual size". I remember seeing some discussion about the nv driver recently in regard to rawhide installs, so I'll see if I can find those or just drive to use the other driver. -- fedora-test-list mailing list fedora-test-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-test-list
