On Mon, 2007-04-30 at 22:15 -0700, Sean Bruno wrote: > Sorry for the late install folks, I know this is T4 and I should have > gotten around to this sooner. It's been a while since I've had some > time to use a test release(I'm not sure where FC7T4 bugs go in bugzilla > even!). > > Not sure why I would get these errors on install, and I'm not quite sure > if they are from my hard drives or my CDROM. I _assume_ that this is a > CDROM drive read failing. I have a Sony DVD Burner, model DRU-800A. > > The system is a dual-opteron running on the ASUS K8N-DL mobo and runs > FC6 x86_64 just fine. > > Using the x86_64 DVD ISO, I attempted to install. The following errors > are the last display on my console after I skip the media check in > anaconda. After selecting skip, I see an error message about anaconda > being terminated. > > -- > <6> device-mapper: multipath emc: version 0.0.3 loaded > <3> SQUASHFS error: sb_bread failed reading block 0x15c5e > <3> SQUASHFS error: Unable to read cache block [5716b1d:16f2] > <3> SQUASHFS error: Unable to read inode [5716b1d:16f2] > <6> sr 3:0:0:0: SCSI error: return code = 0x08000002 > <6> sr0: Current: sense key: Hardware Error > <6> Additional sense: Logical unit communication CRC error > (Ultra-DMA/32) > <4> end_request: I/O error, dev sr0, sector 6424656 > <3> SQUASHFS error: sb_bread failed reading block 0x1bd4 > <3> SQUASHFS error: Unable to read page, block 6f2cfb, size 2566 > <6> sr: 3:0:0:0: SCSI error: return code = 0x08000002 > <6> sr0: Current: sense key: Hardware Error > <6> Additional sense: Logical unit communications CRC error > (Ultra-DMA/32) > <4> end_request: I/O error, dev sr0, sector 6424656 > <6> sr 3:0:0:0: SCSI error: return code = 0x08000002 > <6> sr0: Current: sense key: Hardware Error > <6> Additional sense: Logical unit communication CRC error > (Ultra-DMA/32) > <4> end_request: I/O error, dev sr0, sector 6424656 > <3> SQUASHFS error: sb_bread failed reading block 0x1bd4 > <3> SQUASHFS error: Unable to read page, block 6f2cfb, size 2566 > <3> SQUASHFS error: sb_bread failed reading block 0x1bd4 > <3> SQUASHFS error: Unable to read page, block 6f2cfb, size 2566 > <3> SQUASHFS error: sb_bread failed reading block 0x1bd4 > <3> SQUASHFS error: Unable to read page, block 6f2cfb, size 2566 > > > Sean > Just as a follow up to this issue, https://bugzilla.redhat.com/bugzilla/show_bug.cgi?id=238582 was resolved by attaching a 80-wire IDE cable to the drive. As I say in the ticket, it seems that the new SCSI->ATA stuff or the DVD-ROM drive isn't respecting the mode of the cable. Sean -- fedora-test-list mailing list fedora-test-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-test-list
