How should I go about de debugging this? Should I enter a bug on this?
03:00.0 USB Controller: OPTi Inc. 82C861 (rev 10) (prog-if 10 [OHCI])
Subsystem: OPTi Inc. 82C861
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium
TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64
Interrupt: pin A routed to IRQ 209
Region 0: Memory at 54000000 (32-bit, non-prefetchable) [size=4K]
00: 45 10 61 c8 06 00 80 02 10 10 03 0c 00 40 00 00
10: 00 00 00 54 00 00 00 00 00 00 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 45 10 61 c8
30: 00 00 00 00 00 00 00 00 00 00 00 00 d1 01 00 00
40: 00 00 0f 00 00 00 00 00 00 00 00 00 00 00 00 00
50: 00 01 26 00 30 33 33 33 00 00 00 00 00 00 00 00
60: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
70: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
80: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
90: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
a0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
b0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
c0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
d0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
e0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
f0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
ACPI: bus type pci registered
PCI: PCI BIOS revision 2.10 entry at 0xfd9c2, last bus=2
PCI: Using configuration type 1
Setting up standard PCI resources
ACPI: Interpreter enabled
ACPI: Using IOAPIC for interrupt routing
PM: Adding info for acpi:acpi
ACPI: PCI Root Bridge [PCI0] (0000:00)
PCI: Probing PCI hardware (bus 00)
PM: Adding info for No Bus:pci0000:00
Boot video device is 0000:00:02.0
PCI quirk: region 1000-107f claimed by ICH4 ACPI/GPIO/TCO
PCI quirk: region 1180-11bf claimed by ICH4 GPIO
PCI: Ignoring BAR0-3 of IDE controller 0000:00:1f.1
PCI: Transparent bridge - 0000:00:1e.0
PCI: Bus #03 (-#06) is hidden behind transparent bridge #02 (-#02)
(try 'pci=assign-busses')
Please report the result to linux-kernel to fix this permanently
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
PM: Adding info for pci:0000:00:00.0
PM: Adding info for pci:0000:00:00.1
PM: Adding info for pci:0000:00:00.3
PM: Adding info for pci:0000:00:02.0
PM: Adding info for pci:0000:00:02.1
PM: Adding info for pci:0000:00:1d.0
PM: Adding info for pci:0000:00:1d.1
PM: Adding info for pci:0000:00:1d.2
PM: Adding info for pci:0000:00:1d.7
PM: Adding info for pci:0000:00:1e.0
PM: Adding info for pci:0000:00:1f.0
PM: Adding info for pci:0000:00:1f.1
PM: Adding info for pci:0000:00:1f.3
PM: Adding info for pci:0000:00:1f.5
PM: Adding info for pci:0000:00:1f.6
PM: Adding info for pci:0000:02:00.0
PM: Adding info for pci:0000:02:06.0
PM: Adding info for pci:0000:02:09.0
PM: Adding info for pci:0000:02:09.2
PM: Adding info for pci:0000:02:09.3
PM: Adding info for pci:0000:02:09.4
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.PCIB._PRT]
ACPI: PCI Interrupt Link [LNKA] (IRQs *10)
ACPI: PCI Interrupt Link [LNKB] (IRQs *5)
ACPI: PCI Interrupt Link [LNKC] (IRQs *4)
ACPI: PCI Interrupt Link [LNKD] (IRQs *3)
ACPI: PCI Interrupt Link [LNKE] (IRQs *11)
ACPI: PCI Interrupt Link [LNKF] (IRQs 3) *0, disabled.
ACPI: PCI Interrupt Link [LNKG] (IRQs *4)
ACPI: PCI Interrupt Link [LNKH] (IRQs *3)
ACPI: Embedded Controller [H_EC] (gpe 29) interrupt mode.
Linux Plug and Play Support v0.97 (c) Adam Belay
pnp: PnP ACPI init
PM: Adding info for No Bus:pnp0
PM: Adding info for pnp:00:00
PM: Adding info for pnp:00:01
PM: Adding info for pnp:00:02
PM: Adding info for pnp:00:03
PM: Adding info for pnp:00:04
PM: Adding info for pnp:00:05
PM: Adding info for pnp:00:06
pnp: PnP ACPI: found 7 devices
usbcore: registered new driver usbfs
usbcore: registered new driver hub
PCI: Using ACPI for IRQ routing
PCI: Routing PCI interrupts for all devices because "pci=routeirq" specified
ACPI: PCI Interrupt 0000:00:02.0[A] -> GSI 16 (level, low) -> IRQ 169
ACPI: PCI Interrupt 0000:00:1d.0[A] -> GSI 16 (level, low) -> IRQ 169
ACPI: PCI Interrupt 0000:00:1d.1[B] -> GSI 19 (level, low) -> IRQ 177
ACPI: PCI Interrupt 0000:00:1d.2[C] -> GSI 18 (level, low) -> IRQ 185
ACPI: PCI Interrupt 0000:00:1d.7[D] -> GSI 23 (level, low) -> IRQ 193
ACPI: PCI Interrupt 0000:00:1f.1[A] -> GSI 18 (level, low) -> IRQ 185
ACPI: PCI Interrupt 0000:00:1f.3[B] -> GSI 17 (level, low) -> IRQ 201
ACPI: PCI Interrupt 0000:00:1f.5[B] -> GSI 17 (level, low) -> IRQ 201
ACPI: PCI Interrupt 0000:00:1f.6[B] -> GSI 17 (level, low) -> IRQ 201
ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 16 (level, low) -> IRQ 169
ACPI: PCI Interrupt 0000:02:06.0[A] -> GSI 18 (level, low) -> IRQ 185
ACPI: PCI Interrupt 0000:02:09.0[A] -> GSI 20 (level, low) -> IRQ 209
ACPI: PCI Interrupt 0000:02:09.2[C] -> GSI 22 (level, low) -> IRQ 217
ACPI: PCI Interrupt 0000:02:09.3[A] -> GSI 20 (level, low) -> IRQ 209
ACPI: PCI Interrupt 0000:02:09.4[A] -> GSI 20 (level, low) -> IRQ 209
NetLabel: Initializing
NetLabel: domain hash size = 128
NetLabel: protocols = UNLABELED CIPSOv4
NetLabel: unlabeled traffic allowed by default
PCI: Ignore bogus resource 6 [0:0] of 0000:00:02.0
PCI: Bus 3, cardbus bridge: 0000:02:09.0
IO window: 00003400-000034ff
IO window: 00003800-000038ff
PREFETCH window: 50000000-51ffffff
MEM window: 54000000-55ffffff
PCI: Bridge: 0000:00:1e.0
IO window: 3000-3fff
MEM window: e0200000-e02fffff
PREFETCH window: 50000000-51ffffff
pccard: CardBus card inserted into slot 0
PM: Adding info for pci:0000:03:00.0
PCI: Enabling device 0000:03:00.0 (0000 -> 0002)
ACPI: PCI Interrupt 0000:03:00.0[A] -> GSI 20 (level, low) -> IRQ 209
PCI: Setting latency timer of device 0000:03:00.0 to 64
ohci_hcd 0000:03:00.0: OHCI Host Controller
ohci_hcd 0000:03:00.0: new USB bus registered, assigned bus number 5
ohci_hcd 0000:03:00.0: irq 209, io mem 0x54000000
PM: Adding info for usb:usb5
PM: Adding info for No Bus:usbdev5.1_ep00
usb usb5: configuration #1 chosen from 1 choice
PM: Adding info for usb:5-0:1.0
hub 5-0:1.0: USB hub found
hub 5-0:1.0: 2 ports detected
PM: Adding info for No Bus:usbdev5.1_ep81
pccard: card ejected from slot 0
ohci_hcd 0000:03:00.0: remove, state 4
usb usb5: USB disconnect, address 1
PM: Removing info for No Bus:usbdev5.1_ep81
PM: Removing info for usb:5-0:1.0
PM: Removing info for No Bus:usbdev5.1_ep00
PM: Removing info for usb:usb5
ohci_hcd 0000:03:00.0: USB bus 5 deregistered
ACPI: PCI interrupt for device 0000:03:00.0 disabled
PM: Removing info for pci:0000:03:00.0
PCMCIA: socket c18e6124: *** DANGER *** unable to remove socket power
--
fedora-test-list mailing list
fedora-test-list@xxxxxxxxxx
To unsubscribe:
https://www.redhat.com/mailman/listinfo/fedora-test-list