I'm attempting to install a FC5 guest in Xen on FC5, 2041 xen0 kernel. I've gotten to the point where anaconda runs and starts presenting me with menus. Unfortunately, the 3rd menu it presents is stopping me, the one which sets the IP address.
If I select DHCP and networking is set up for NAT, it thinks for a bit and then returns to the same page. If I try to manually specify an IP address, it thinks for a bit, and then segfaults. If networking is bridged, it segfaults in either case.
The command I'm running is:
xenguest-intall.py -n vm2 -f /root/fedora.img -s 6 -r 256 -p -l ftp://mymachine
I've tried this with the networking setup as bridged or NAT, but the result is always the same.
Any thoughts?
-- Scott
-----------------------------
In the beginning, there was nothing, then God said, "Let there be light."
And there was light. There was still nothing, but you could see it a lot better.
-- fedora-test-list mailing list fedora-test-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-test-list