On Fri, 2005-05-13 at 12:15 -0400, Gene C. wrote: > I have a Dell 2000FB (flat panel) display on my system and it is connected to > an ATI 9100 adapter via the analog rather than the DVI-D connector. > > With previous version of FC (even FC4T2), this worked fine with my selection > of 1600x1200. However, with FC4T3, the virtical display is fine but the > horizontal seems to use a physical size a bit smaller and I end up with a > "virtual screen" horizontally (I can see the edges only by using the mouse to > "move" the screen). > > (intended) feature or bug? I had the same thing on a fresh FC4T3 install at 1600x1200 with an ATI Radeon 9000 card and an IBM P202 21" monitor. First I made a backup of /etc/X11/xorg.conf then tried system-config-display --reconfig which crashed horribly (no idea why). Then had a look in xorg.conf and removed all the different resolutions so only "1600x1200" was still there. I then restarted X and all was well. Regards, Patrick