hi,
I have two cdrw burners in my box, but only one is found with
$cdrecord -scanbus
Cdrecord-Clone 2.01-dvd (i686-pc-linux-gnu) Copyright (C) 1995-2004 Jörg
Schilling
Note: This version is an unofficial (modified) version with DVD support
Note: and therefore may have bugs that are not present in the original.
Note: Please send bug reports or support requests to
http://bugzilla.redhat.com/bugzilla
Note: The author of cdrecord should not be bothered with problems in
this version.
scsidev: 'ATA'
devname: 'ATA'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Using libscg version 'schily-0.8'.
cdrecord: Warning: using inofficial libscg transport code version
(schily - Red Hat-scsi-linux-sg.c-1.83-RH '@(#)scsi-linux-sg.c 1.83
04/05/20 Copyright 1997 J. Schilling').
scsibus1:
1,0,0 100) *
1,1,0 101) 'HL-DT-ST' 'DVDRAM GSA-4040B' 'A301' Removable CD-ROM
1,2,0 102) *
1,3,0 103) *
1,4,0 104) *
1,5,0 105) *
1,6,0 106) *
1,7,0 107) *
this one is attached on /dev/hdd and it works Ok.
But second drive is scsi, and is also found by my kernel:
$dmesg | grep -i scsi
SCSI subsystem initialized
ahc_pci:0:10:0: Host Adapter Bios disabled. Using default SCSI device
parameters
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
<Adaptec 2902/04/10/15/20C/30C SCSI adapter>
aic7850: Single Channel A, SCSI Id=7, 3/253 SCBs
(scsi0:A:3): 10.000MB/s transfers (10.000MHz, offset 15)
Type: CD-ROM ANSI SCSI revision: 02
sr0: scsi3-mmc drive: 24x/24x writer cd/rw xa/form2 cdda tray
Should I insert some module to get it working, I also notice that there
is no device for scsi cdrw?!?
Any suggestions?
regards bruma