On Wed, 2004-11-17 at 15:16 -0500, Joe Borne wrote: > OK, I now have Solaris 10 installed on a 2nd internal HD. However, > when I attempted to modify the grub boot loader I am stymied by the > way FC3 set up my system. > > The grub entyr I put in is: > > title Solaris 10 > rootnoverify (hd3,1) If this is indeed your second internal HD (well should be because your BIOS can only access the first two HDs), it should be (hd1,1) -- grub configuration is done from a BIOS point of view. > makeactive > chainloader +1 > > Because I now have Sol10 on /dev/hdc, partition 1 Did it install its bootloader at the beginning of the first partition or into the MBR of that disk? > > But FC3 configured my system with the internal drive as an LVM (smart, > I liked that, but now it's a new wrinkle). > > So my fstab is this: > > /dev/VolGroup00/LogVol00 / ext3 defaults 1 1 > LABEL=/boot /boot ext3 defaults 1 2 > none /dev/pts devpts gid=5,mode=620 0 0 > none /dev/shm tmpfs defaults 0 0 > none /proc proc defaults 0 0 > none /sys sysfs defaults 0 0 > /dev/VolGroup00/LogVol01 swap swap defaults 0 0 > /dev/hdd /media/cdrw_dvdr auto > noauto,user,exec,managed,ro 0 0 > /dev/fd0 /media/floppy auto > noauto,user,exec,managed 0 0 > > > So when I attempt to perform the following sequence, grub does not > recognize any of the drives I am calling for. Do you mean it refuses to install the MBR or that booting Solaris doesn't work (I'd expect that it wouldn't given your config above) or that booting in general doesn't work? Nils -- Nils Philippsen / Red Hat / nphilipp@xxxxxxxxxx "They that can give up essential liberty to obtain a little temporary safety deserve neither liberty nor safety." -- B. Franklin, 1759 PGP fingerprint: C4A8 9474 5C4C ADE3 2B8F 656D 47D8 9B65 6951 3011