Qianqian Fang wrote, at 12/12/2007 03:39 AM +9:00:
hi
I want to add a separate configuration file (61-wqy-bitmapsong.conf)
to package wqy-bitmap-fonts, after reading some examples, I used
the following syntax to make this change
....
Source0: http://url of the upstream package
Source1: 61-wqy-bitmapsong.conf # the additional file
....
%setup -q -n %{wqyroot}
...
%install
...
install -p -m644 %{SOURCE1} %{buildroot}%{fontconfigdir}/
...
then I copied 61-wqy-bitmapsong.conf to "devel" directory,
and "cvs add 61-wqy-bitmapsong.conf". However, it failed when
I test the build with "make i386", the error message is
File Not found: ..../wqy-bitmap-fonts/devel/61-wqy-bitmapsong.conf
Installed (but unpackaged) file(s) found
/etc/fonts/conf.d/61-wqy-bitmapsong.conf
did I miss anything? where should I put the 61-wqy-bitmapsong.conf
when commit to cvs?
Well, the problem is not there. Actually the build log says
/etc/fonts/conf.d/61-wqy-bitmapsong.conf is found but your spec
file reads:
----------------------------------------------
%files
....................
%config(noreplace) %{fontconfdir}/%{SOURCE1}
----------------------------------------------
Here SOURCE1 is expanded to %_sourcedir/`basename %SOURCE1`.
As the result %{fontconfdir}/%{SOURCE1} is not found but
/etc/fonts/conf.d/61-wqy-bitmapsong.conf is left installed
but not registered.
Regards,
Mamoru Tasaka <mtasaka@xxxxxxxxxxxxxxxxxxx>
--
fedora-devel-list mailing list
fedora-devel-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/fedora-devel-list
