On Thu, Nov 15, 2007 at 08:56:46PM -0500, eah wrote: > I have the BCM4318 wlan0. b43 driver picks it up after following instructions > using broadcom-wl-4.80.53.0.tar.bz2. It does not active the card's radio (my > little blue light stays dark to say it like an end user) . dmesg > reports "ADDRCONF(NETDEV_UP): wlan0: link is not ready" To answer your later question, this is the right firmware. I am presuming that you extracted the firmware already. > What do I need to do to get that working? > > This is the farthest I've ever gotten using the stock driver, so kudos to all > involved in that. Are these your only indications? Did you actually try to activate the card using NetworkManager, wpa_supplicant, or iwconfig? Regarding the "little blue light", did you try pushing the RF kill button? Sometimes they are a software-controlled toggle rather than an actual physical switch. (Note: don't bother with this without trying NetworkManger, et al. first...) John -- John W. Linville linville@xxxxxxxxxx -- fedora-devel-list mailing list fedora-devel-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/fedora-devel-list
