dragoran wrote:
Martin Sourada wrote:
Bill Nottingham wrote:
John W. Linville (linville@xxxxxxxxxx) said:
Hm... when I try to add new device in system-config-network I can
choose only eth* (though I can write there wlan0 manually), but I
don't know which adapter to choose, because mine does not seems to
be listed there... I think it should be detected and set
automatically like in previous versions of fedora.
Hmmm...my wlan0 shows-up there automatically...Bill?
kudzu -p -c network? (Or does s-c-network use HAL these days?)
Bill
what about adding
alias wlan0 bmc43xx_mac80211 to modprobe.conf ?
does system-config network detect it than?
Hm... the system-config-network then shows it in the hardware list and allows me
to create a device. If I run ifup wlan0 however, I get this error:
Error for wireless request "Set Bit Rate" (8B20) :
SET failed on device wlan0 ; Operation not supported.
And it fails to connect - but that is OK, since I don't have there any wireless
network I have access to...
Maybe I should try eth1, as kudzu find it as eth1? Or is wireless supposed to be
handled by NetworkManager completely?
Thanks,
Martin
--
fedora-devel-list mailing list
fedora-devel-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/fedora-devel-list
