On Monday 13 December 2004 14:08, Sam Hart wrote: > This occurs during installation. It occurs only on the hardware I > mentioned, namely: > * HP Proliant DL380 > * HP SmartArray 5i RAID controller card Having recently completed beating my head against the wall to get FC3 installed and running on a Proliant DL360 G2 ... have you set the system type to "Linux"? Untill I realized that this needed to be done, it was a lot of pain. If the Dl380 is anything like the DL360 G2, you need to hit F9 during the initial stuff the system goes through (it is toward the end), this will bring up configuration of the BIOS stuff where you can select system type. I found that it needed to be set BEFORE you did the install. Why the Compaq/HP Proliant needs to know the system type it will be running is a puzzle to me. -- Gene
