Is it normal for the kernel to try to probe IDE interfaces that don't exist? Anyone else have get these messages? Nothing adverse happens, not that I can see anyway.
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx SIS5513: IDE controller at PCI slot 0000:00:02.5 SIS5513: chipset revision 208 SIS5513: not 100% native mode: will probe irqs later SIS5513: SiS735 ATA 100 (2nd gen) controller ide0: BM-DMA at 0xff00-0xff07, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0xff08-0xff0f, BIOS settings: hdc:DMA, hdd:DMA Probing IDE interface ide0... hda: WDC WD800JB-00FMA0, ATA DISK drive Using cfq io scheduler ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... hdc: DVD-RW IDE1008, ATAPI CD/DVD-ROM drive hdd: PLEXTOR CD-R PX-W1610A, ATAPI CD/DVD-ROM drive ide1 at 0x170-0x177,0x376 on irq 15 Probing IDE interface ide2... ide2: Wait for ready failed before probe ! Probing IDE interface ide3... ide3: Wait for ready failed before probe ! Probing IDE interface ide4... ide4: Wait for ready failed before probe ! Probing IDE interface ide5... ide5: Wait for ready failed before probe !
