W dniu 07.10.2011 17:23, Reindl Harald pisze: > hi > > i have two machines with the same USB3 card and massive problems > with two different external disks - should this be a bugreport for > the kernel? i am wondering about this troubles because AFAIK the > linux-kernel was first with support for USB3 and that 2 different > disks and/or both controllers are defect is not realistic > > * below after the first connect only an error (2 TB disk) > * second connect much more errors but device deteced > * after crash of the usb-controller only reboot let appear any drive again > * the third output is from anothr device with 500GB > > the 500GB works mostly but had also lost data, the 2 TB drive > is unusable and data are destroyed (luks-container) > > 2.6.40.6-0.fc15.x86_64 #1 SMP Tue Oct 4 00:39:50 > 02:00.0 USB Controller: NEC Corporation uPD720200 USB 3.0 Host Controller (rev 03) > ______________________________________________ > > usb 4-1: new SuperSpeed USB device number 2 using xhci_hcd > xhci_hcd 0000:02:00.0: WARN: short transfer on control ep > xhci_hcd 0000:02:00.0: WARN: short transfer on control ep > xhci_hcd 0000:02:00.0: WARN: short transfer on control ep > usb 4-1: New USB device found, idVendor=174c, idProduct=5106 > usb 4-1: New USB device strings: Mfr=2, Product=3, SerialNumber=1 > usb 4-1: Product: AS2105 > usb 4-1: Manufacturer: ASMedia > usb 4-1: can't set config #1, error -110 > ______________________________________________ > > usb 4-1: USB disconnect, device number 2 > hub 4-0:1.0: unable to enumerate USB device on port 1 > usb 4-1: new SuperSpeed USB device number 4 using xhci_hcd > xhci_hcd 0000:02:00.0: WARN: short transfer on control ep > xhci_hcd 0000:02:00.0: WARN: short transfer on control ep > xhci_hcd 0000:02:00.0: WARN: short transfer on control ep > xhci_hcd 0000:02:00.0: WARN: short transfer on control ep > usb 4-1: New USB device found, idVendor=174c, idProduct=5106 > usb 4-1: New USB device strings: Mfr=2, Product=3, SerialNumber=1 > usb 4-1: Product: AS2105 > usb 4-1: Manufacturer: ASMedia > usb 4-1: SerialNumber: WD-WCAWZ0975740 > scsi9 : usb-storage 4-1:1.0 > scsi 9:0:0:0: Direct-Access WDC WD20 EARS-00J99B0 80.0 PQ: 0 ANSI: 0 > sd 9:0:0:0: Attached scsi generic sg10 type 0 > sd 9:0:0:0: [sdj] 3907029168 512-byte logical blocks: (2.00 TB/1.81 TiB) > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 9:0:0:0: [sdj] Write Protect is off > sd 9:0:0:0: [sdj] Mode Sense: 23 00 00 00 > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 9:0:0:0: [sdj] No Caching mode page present > sd 9:0:0:0: [sdj] Assuming drive cache: write through > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 9:0:0:0: [sdj] No Caching mode page present > sd 9:0:0:0: [sdj] Assuming drive cache: write through > sdj: sdj1 > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 9:0:0:0: [sdj] No Caching mode page present > sd 9:0:0:0: [sdj] Assuming drive cache: write through > sd 9:0:0:0: [sdj] Attached SCSI disk > sd 9:0:0:0: [sdj] Sense Key : Recovered Error [current] [descriptor] > Descriptor sense data with sense descriptors (in hex): > 72 01 04 1d 00 00 00 0a 09 0c 00 00 00 00 00 07 > 00 00 > sd 9:0:0:0: [sdj] ASC=0x4 ASCQ=0x1d > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 9:0:0:0: [sdj] Sense Key : Recovered Error [current] [descriptor] > Descriptor sense data with sense descriptors (in hex): > 72 01 04 1d 00 00 00 0e 09 0c 00 00 00 00 00 07 > 00 00 00 00 40 50 > sd 9:0:0:0: [sdj] ASC=0x4 ASCQ=0x1d > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 9:0:0:0: [sdj] Sense Key : Recovered Error [current] [descriptor] > Descriptor sense data with sense descriptors (in hex): > 72 01 04 1d 00 00 00 0e 09 0c 00 00 00 00 e8 87 > 00 7f 00 e0 40 50 > sd 9:0:0:0: [sdj] ASC=0x4 ASCQ=0x1d > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 9:0:0:0: [sdj] Sense Key : Recovered Error [current] [descriptor] > Descriptor sense data with sense descriptors (in hex): > 72 01 04 1d 00 00 00 0e 09 0c 00 00 00 00 00 07 > 00 08 00 00 40 50 > sd 9:0:0:0: [sdj] ASC=0x4 ASCQ=0x1d > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 9:0:0:0: [sdj] Sense Key : Recovered Error [current] [descriptor] > Descriptor sense data with sense descriptors (in hex): > 72 01 04 1d 00 00 00 0e 09 0c 00 00 00 00 00 0f > 00 08 00 00 40 50 > sd 9:0:0:0: [sdj] ASC=0x4 ASCQ=0x1d > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 9:0:0:0: [sdj] Sense Key : Recovered Error [current] [descriptor] > Descriptor sense data with sense descriptors (in hex): > 72 01 04 1d 00 00 00 0e 09 0c 00 00 00 00 e8 00 > 00 4f 00 c2 00 50 > sd 9:0:0:0: [sdj] ASC=0x4 ASCQ=0x1d > ______________________________________________ > > usb 4-1: new SuperSpeed USB device number 6 using xhci_hcd > xhci_hcd 0000:02:00.0: WARN: short transfer on control ep > xhci_hcd 0000:02:00.0: WARN: short transfer on control ep > xhci_hcd 0000:02:00.0: WARN: short transfer on control ep > xhci_hcd 0000:02:00.0: WARN: short transfer on control ep > usb 4-1: New USB device found, idVendor=04e8, idProduct=60a3 > usb 4-1: New USB device strings: Mfr=1, Product=11, SerialNumber=3 > usb 4-1: Product: Samsung S2 Portable 3 > usb 4-1: Manufacturer: JMicron > usb 4-1: SerialNumber: 00000000011E0AC9 > scsi10 : usb-storage 4-1:1.0 > scsi 10:0:0:0: Direct-Access Samsung S2 Portable 3 3 PQ: 0 ANSI: 6 > sd 10:0:0:0: Attached scsi generic sg10 type 0 > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 10:0:0:0: [sdj] 976752688 512-byte logical blocks: (500 GB/465 GiB) > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 10:0:0:0: [sdj] Write Protect is off > sd 10:0:0:0: [sdj] Mode Sense: 27 00 00 00 > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 10:0:0:0: [sdj] No Caching mode page present > sd 10:0:0:0: [sdj] Assuming drive cache: write through > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 10:0:0:0: [sdj] No Caching mode page present > sd 10:0:0:0: [sdj] Assuming drive cache: write through > sdj: sdj1 sdj2 sdj3 > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > xhci_hcd 0000:02:00.0: WARN: Stalled endpoint > sd 10:0:0:0: [sdj] No Caching mode page present > sd 10:0:0:0: [sdj] Assuming drive cache: write through > sd 10:0:0:0: [sdj] Attached SCSI disk > > > > > Hi, I am also having annoying issues with USB3. It seems like the best place to get help is linux-usb mailing list. Julian -- devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/devel
