Nik, Thanks for your suggestion. I wish it was just a simple jumper mis-configuration. The new drive is on a separate IDE controller, all by itself, so there's no problem with the jumper settings. Everything works as expected when I boot using Windows. Any other ideas? -----Original Message----- From: nicola [mailto:nicola]On Behalf Of Nik Sent: Thursday, May 01, 2003 3:42 PM To: Andrew Chen Cc: Stephen C. Tweedie; ext3 users list Subject: Re: mount: error 22 mounting ext3 Andrew Chen wrote: > I am unable to boot my original RH 9 with the RH 7.2 drive installed. If I > disconnect the the drive (RH 7.2 w/ ext2), then RH 9 boots up fine. > > The RH 7.2 drive used to be the boot drive for another system. Now I just > want to use it as additional storage in my RH 9 system. Hope this clarifies > my system problems. > May I suggest that the new drive is incorrectly set as "Master" on the ide connector? The original drive should have the jumpers set to "Master", the RH7.2 one on "slave". _______________________________________________ Ext3-users@redhat.com https://listman.redhat.com/mailman/listinfo/ext3-users
