On Thu, Jan 21, 2016 at 12:39:41PM +0530, Archit Taneja wrote: > Add hdmi phy bindings. Update the example to use hdmi phy. > > Add a missing power-domains property in the hdmi core bindings. > > Cc: devicetree@xxxxxxxxxxxxxxx > Cc: Rob Herring <robh@xxxxxxxxxx> > > Signed-off-by: Archit Taneja <architt@xxxxxxxxxxxxxx> > --- > .../devicetree/bindings/display/msm/hdmi.txt | 39 +++++++++++++++++++++- > 1 file changed, 38 insertions(+), 1 deletion(-) > > diff --git a/Documentation/devicetree/bindings/display/msm/hdmi.txt b/Documentation/devicetree/bindings/display/msm/hdmi.txt > index 379ee2e..21590ee 100644 > --- a/Documentation/devicetree/bindings/display/msm/hdmi.txt > +++ b/Documentation/devicetree/bindings/display/msm/hdmi.txt > @@ -11,6 +11,7 @@ Required properties: > - reg: Physical base address and length of the controller's registers > - reg-names: "core_physical" > - interrupts: The interrupt signal from the hdmi block. > +- power-domains: Should be <&mmcc MDSS_GDSC>. > - clocks: device clocks > See ../clocks/clock-bindings.txt for details. > - qcom,hdmi-tx-ddc-clk-gpio: ddc clk pin > @@ -18,6 +19,7 @@ Required properties: > - qcom,hdmi-tx-hpd-gpio: hpd pin > - core-vdda-supply: phandle to supply regulator > - hdmi-mux-supply: phandle to mux regulator > +- qcom,dsi-phy: phandle to HDMI PHY device node dsi? Why does this not use the phy binding? Rob _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/dri-devel