|
Hi Thierry, 在 09/03/2015 05:04 PM, Thierry Reding
写道:
On Thu, Sep 03, 2015 at 12:27:47PM +0800, Yakir Yang wrote:Hi Rob, 在 09/03/2015 04:17 AM, Rob Herring 写道:On Tue, Sep 1, 2015 at 1:14 AM, Yakir Yang <ykk@xxxxxxxxxxxxxx> wrote:Some edp screen do not have hpd signal, so we can't just return failed when hpd plug in detect failed.This is a property of the panel (or connector perhaps), so this property should be located there. At least, it is a common issue and not specific to this chip. We could have an HDMI connector and failed to hook up HPD for example. A connector node is also where hpd-gpios should be located instead (and are already defined by ../bindings/video/hdmi-connector.txt). Perhaps we need a eDP connector binding, too.Yep, I agree with your front point, it is a property of panel, not specific to eDP controller, so this code should handle in connector logic.>From your description it sounds more like this is in fact a property of the panel. Or maybe I should say "quirk". If the panel doesn't generate the HPD signal, then that should be a property of the panel, not the connector. The eDP specification mandates that connectors have a HPD signal, though it allows the "HPD conductor in the connector cable" to be omitted if not used by the source. I'd consider the cable to belong to the panel rather than the connector, so absence of HPD, either because the cable doesn't have the conductor or because the panel does not generate the signal, should be a quirk of the panel. That said you could have a panel that supports HPD connected via a cable that doesn't transmit it, so this would be a per-board variant and hence should be a device tree property rather than hard-coded in some panel driver. Conversely, if the panel isn't capable of generating an HPD signal, then I don't think it would be appropriate to make it a DT property. It would be better to hard-code it in the driver, lest someone forget to set the property in DT and get stuck with a device that isn't operational. Oh, you're right, if it's a cable quirk, then DT property would be okay, if it is a problem of panel, then maybe hard-code in driver would be better. After look up for the document of panel "innolux,n116bge", I haven't see any description of hot plug signal, and even not found in PIN ASSIGNMENT. So I believe it's a panel problem, that's to say it should handle in panel driver. Hmm... But I don't know how to cover the whole hpd situation in panel detect, it looks complicate *_* And Russell have remind that DRM .force is another way to handle this one, but I haven't understand it very well. I see we need make connector->force = DRM_FORCE_ON, then we can enable eDP in connector->funcs->force(). But I don't how to handle connector->force automatically without DT property, could some guys help here :-D Thanks, - Yakir |
_______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/dri-devel
