Hi Thierry,
在 2015/8/25 17:15, Thierry Reding 写道:
On Sun, Aug 23, 2015 at 06:23:14PM -0500, Rob Herring wrote:
On Wed, Aug 19, 2015 at 9:50 AM, Yakir Yang <ykk@xxxxxxxxxxxxxx> wrote:
[...]
+ -analogix,link-rate:
+ max link rate supported by the eDP controller.
+ LINK_RATE_1_62GBPS = 0x6, LINK_RATE_2_70GBPS = 0x0A,
+ LINK_RATE_5_40GBPS = 0x14
Same here. I'd rather see something like "link-rate-mbps" and use the
actual rate.
There is no need whatsoever to hard-code this in DT. (e)DP provides the
means to detect what rate the link supports and the specification
provides guidance on how to select an appropriate one.
Hmm... could you share more about this :-)
I only find that drm_dp_link_probe() could get the panel link-rate and
num-lanes by reading the DP_DPCD_REV messag.
I don't found there are some guidance to help select the approriate one.
Beside this DT prop just indicate the max eDP controller link-rate & lanes
support, how could eDP detect them automatically?
- Yakir
+ -analogix,lane-count:
+ max number of lanes supported by the eDP contoller.
+ LANE_COUNT1 = 1, LANE_COUNT2 = 2, LANE_COUNT4 = 4
And drop the vendor prefix here.
Same as for the link rate.
Thierry
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/dri-devel
